Husqvarna 323P4 325P5 X-Series Chainsaw Owners Manual

MAINTENANCE
Oiling the air filter
Weekly maintenance
Check the starter, the starter cord and the recoil spring.
Clean the air filter.
Always use HUSQVARNA filter oil, art. no. 503 47 73-01.The
filter oil contains a solvent to make it spread evenly through
the filter.You should therefore avoid skin contact.
Clean the carburettor compartment.
Clean the outside of the spark plug. Remove and check
the electrode gap.Adjust the gap to 0.5 mm or change the
spark plug.
Put the filter in a plastic bag and pour the filter oil over it.
Knead the plastic bag to distribute the oil. Squeeze the
excess oil out of the filter inside the plastic bag and pour off
the excess before fitting the filter to the machine. Never use
common engine oil.This would drain through the filter quite
quickly and collect in the bottom.
Clean the cooling fins on the cylinder and check that the
air intake near the starter is not blocked.
Clean or replace the spark arrestor mesh on the muffler
(only applies to mufflers without a catalytic converter).
File off any burrs from the edges of the bar.
Monthly maintenance
Clean the fuel tank.
Clean the outside of the carburettor and the space around
it.
Bevel gear
Clean the fan and the area around it.
Check fuel hose for cracks or other damage. Change if
necessary.
Check all cables and connections.
Check the clutch, clutch springs and the clutch drum for
wear. Replace if necessary.
The bevel gear is filled with the right quantity of grease at the
factory.However, before using the machine you should check
that the bevel gear is filled three-quarters full with grease.Use
HUSQVARNA special grease.
Replace the spark plug.Check that the spark plug is fitted
with a suppressor.
Replace the air filter.
Check and clean the spark arrestor mesh on the muffler
(only applies to mufflers fitted with a catalytic converter).
The grease in the bevel gear does not normally need to be
changed except if repairs are carried out.
Maintenance schedule
Below you will find some general maintenance instructions. If
you need further information please contact your service
workshop.
Daily maintenance
Clean the outside of the machine.
Check throttle trigger and throttle trigger lockout function.
Check that the stop switch works correctly.
Check that the cutting attachment does not rotate at idle.
Check that the harness is undamaged.
Check that nuts and screws are tight.
Check that there are no fuel leaks.
Clean the area under the protective cover.
English – 23
Product Specification
CategoriesChainsaw Manuals, Husqvarna Chainsaw Manuals
Tags, ,
Model Year2003
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 32 pages
Document TypeOperator's Manual
LanguageEnglish
Product BrandHusqvarna, Chainsaw
Document File TypePDF
Publisherhusqvarna.com
Wikipedia's PageHusqvarna
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website