Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Maintenance Procedure
Interval
•
Inspect the traction cable and adjust it if necessary.
• Inspect the auger/impeller cable and adjust it if necessary.
Change the engine oil.
After the first 2 hours
•
Before each use or daily
• Check the engine oil level and add oil if necessary.
•
•
•
Check the skids and the scraper and adjust them if necessary.
Inspect the traction cable and adjust or replace it if necessary.
Inspect the auger/impeller cable and adjust or replace it if necessary.
Yearly
• Check the auger gearbox oil and add oil if necessary.
•
•
•
Change the engine oil.
Lubricate the hex shaft.
Inspect the spark plug. Replace and/or gap it if necessary.
•
•
Check the air pressure in the tires and inflate them to 17–20 psi (116–137 kPa).
Drain the gasoline and run the engine to dry out the fuel tank and the carburetor at
the end of the season.
Yearly or before storage
•
Have an Authorized Service Dealer inspect and replace the traction drive belt and/or
the auger/impeller drive belt, if necessary.
Important: You can find more information about maintaining and servicing your snowthrower at
www.Toro.com.
Important: Refer to your engine operator’s manual for additional maintenance procedures. For engine
adjustments, repairs, or warranty service not covered in this manual, contact an Authorized Tecumseh
Servicing Dealer.
Preparing for Maintenance
Checking the Engine Oil Level
1.
2.
3.
Move the snowthrower to a level surface.
Service Interval: Before each use or daily—Check
the engine oil level and add oil if
necessary.
Stop the engine and wait for all moving parts to stop.
Disconnect the spark plug wire (Figure 41).
1.
Remove the dipstick, wipe it clean, then fully install
the dipstick.
2.
Remove the dipstick and check the oil level
(Figure 42). If the oil level is below the Add mark
on the dipstick, add oil. Refer to Filling the Engine
with Oil.
Figure 41
19
Categories | Snow Blower Manuals, Toro Snow Blower |
---|---|
Tags | Toro 38630, Toro Power Max 828LXE |
Model Number | 38630 |
Model Year | 2007 |
Download File |
|
Document Type | Operator's Manual |
Language | English |
Serial Number | 270000001 - 270999999 |
Product Name | Toro Power Max 828 LXE Snowthrower |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower |
Product Type | Snowthrower |
Product Series | Two Stage Power Max |
Swath | 28 inch |
Discharge | Two Stage |
Engine Manufacturer | Tecumseh |
Engine Oil Type | 26 oz. (.8l) 5w-30 or 10w / API SH or higher |
Gearbox Lubricant | 4.5 oz. (133ml) SAE 90 GL5 or higher |
Engine Motor Model # | LH318SA-156563H |
Engine Motor Type | 4 Cycle CARB2, EPA2 |
Transmission Speed | 6 Forward/2 Reverse |
Transmission Type | Friction Disc |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)