Axle Lock Pin (Figure 10)
Wheel Unlocked
FILLING FUEL TANK
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Fuel Shut-Off Valve
IMPORTANT: The fuel shut-off valve MUST be
in the closed position prior to transporting the
unit.
The fuel shut-off valve has two positions:
•
Closed Position: Use this position to
service, transport, or store the unit.
•
Open Position: Use this position to run the
unit.
Axle
Lock
Pin
To add fuel to fuel tank:
Wheel Locked
1.
ALWAYS place unit in open or well-
ventilated area.
2.
3.
Stop engine and allow to cool.
Clean Fuel Cap and surrounding area to
prevent dirt from entering Fuel Tank.
4.
Remove Cap.
IMPORTANT: DO NOT use gasohol or
gasoline containing alcohol. See Engine
Manual for correct type and grade of fuel.
5.
Fill fuel tank to within 1/2 in. (1.2 cm)
below bottom of filler neck with unleaded
gasoline.
NOTE: Tank capacity is 3.5 qt (3.3 L) (932037,
039, 505, 509) or 2 qt (1.96 L) (932038, 507).
Figure 10
6. Replace Fuel Cap and tighten.
7.
ALWAYS clean up any spilled fuel.
Use the axle lock pin to lock or unlock the right
wheel. Lock the right wheel to increase
traction; unlock the right wheel to allow for
easier turning of the unit.
PRE-START
1.
Frozen Impeller
IMPORTANT: Before starting engine, check
impeller to be sure it is not frozen.
Scraper Blade
The scraper blade allows the back of the
housing to keep better contact with the surface
being cleared. It also prevents damage to the
housing from normal wear.
To check impeller:
1.
With key in “Stop” position, squeeze
Attachment Clutch Bail to Engaged
position.
IMPORTANT: DO NOT allow Scraper Blade to
wear too far or Auger/Impeller housing will
become damaged.
2.
3.
Pull Recoil Starter Handle.
If Impeller is frozen, (cannot pull Starter
Handle) move unit to a heated area and
thaw to prevent possible damage.
Runners
The runners control the distance between the
scraper blade and the ground. Adjust runners
equally to keep blade level with the ground.
Refer to Pre-Start for recommended settings.
2.
Check Function of Clutches
If clutches do not engage or disengage
properly, adjust or repair before operation (see
Service and Adjustments).
3.
Adjust Axle Lock
Use the axle lock pin to lock or unlock the right
wheel. Lock the right wheel to increase
traction; unlock the right wheel to allow for
easier turning of the unit.
GB - 15
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 932037-724, Ariens 932038-5520, Ariens 932039-624, Ariens 932505-724, Ariens 932507-520, Ariens 932508-624 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)