This product is equipped with an internal
combustion type engine. DO NOT use unit on
or near any unimproved, forest-covered or
brush covered land unless exhaust system is
equipped with a spark arrester meeting
applicable local, state or federal laws. A spark
arrester, if it is used, must be maintained in
effective working order by operator.
Before tipping unit up onto housing, remove
fuel so no spills will occur. Ensure unit is
secure and will not tip over during
maintenance.
ALWAYS keep protective structures, guards,
and panels in good repair, in place and
securely fastened. NEVER modify or remove
safety devices.
Fuel is highly flammable and its vapors are
explosive. Handle with care. Use an approved
fuel container.
DO NOT change engine governor settings or
over-speed engine.
Fumes from engine exhaust can cause injury
or death. DO NOT run engine in an enclosed
area. Always provide good ventilation.
NO smoking, NO sparks, NO flames. ALWAYS
allow engine to cool before servicing.
NEVER fill fuel tank when engine is running or
hot from operation.
ALWAYS maintain unit in safe operating
condition. Damaged or worn out muffler can
cause fire or explosion.
NEVER fill or drain fuel tank indoors.
Replace fuel cap securely and clean up spilled
fuel.
Keep all hardware properly tightened. Check
shear bolts frequently.
Never fill containers inside a vehicle or on a
truck or trailer bed with a plastic liner. Always
place containers on the ground away from
your vehicle before filling.
Maintain or replace safety and instruction
labels, as necessary.
NEVER store unit with fuel in fuel tank, inside
a building where any ignition sources are
present such as hot water heaters, space
heaters, or clothes dryers. Allow the engine to
cool before storing in any enclosure.
When practical, remove gas-powered
equipment from the truck or trailer and refuel it
on the ground. If this is not possible, then
refuel such equipment on a trailer with a
portable container, rather than from a gasoline
dispenser nozzle.
Shut off fuel and allow engine to cool
completely before storing in closed area or
covering unit.
Keep the nozzle in contact with the rim of the
fuel tank or container opening at all times until
fueling is complete. Do not use a nozzle lock-
open device.
For extended storage, clean unit thoroughly.
See Engine Manual for proper storage.
Use only attachments or accessories designed
for your unit.
If fuel is spilled on clothing, change clothing
immediately.
Check components frequently. If worn or
damaged, replace with manufacturer’s
recommended parts.
ASSEMBLY
ASSEMBLY
Unfold Handlebar (Figure 4)
1. Loosen wing knobs and release J-bolts
from lower handlebar.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
2.
3.
4.
Unfold upper handlebar and align
handlebar holes.
Put J-bolts through the upper handlebar
and lower handlebar holes.
Tighten wing knobs to secure upper
handlebar.
WARNING: Dropping or tipping over
boxed unit could result in personal
injury or damage to unit.
Tools Required:
•
•
Pliers
Open-End Wrenches: 3/8, 7/16, 1/2,
9/16
in. and/or Adjustable Wrench
•
Tire Gauge
GB - 9
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 932037-724, Ariens 932038-5520, Ariens 932039-624, Ariens 932505-724, Ariens 932507-520, Ariens 932508-624 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)