Shut Off
To clear an area, run unit in an overlapping
series of paths. For large areas, start in the
middle and throw snow to each side, so snow
is not cleared more than once.
1.
Release Traction Drive Clutch Bail and
allow unit to come to a complete stop.
Run Impeller a few minutes after use to
prevent freeze-up of Impeller.
2.
ALWAYS direct snow away from area to be
cleared and with direction of the wind.
3.
Release Attachment Clutch Bail and wait
for all moving parts to come to a complete
stop.
TRAVELING
To travel from one work area to another:
4.
5.
Move Throttle to the “Stop” position.
Remove key.
1.
Set Throttle to Slow or Part-Throttle
position.
SNOW REMOVAL
2. Press down on handlebars enough to
raise front of unit slightly off surface.
IMPORTANT: Allow unit and engine to adjust
to the outdoor temperatures before clearing
snow.
3. Engage wheel drive clutch without
engaging attachment drive clutch.
NOTE: Attachment clutch should be engaged
before wheel drive clutch when throwing snow.
TRANSPORT
1.
2.
3.
Select Speed Control position and
direction.
ALWAYS shut off engine, remove key, and
close fuel shut-off valve when transporting unit
on a truck or trailer.
Engage Attachment Clutch - Right Hand
Bail.
Use extra care when loading or unloading unit
onto trailer or truck.
Engage Traction Drive Clutch - Left Hand
Bail.
Secure unit chassis to transport vehicle.
NEVER secure from rods or linkages that
could be damaged.
IMPORTANT: DO NOT overload unit capacity
by attempting to clear snow at too fast a rate.
Use slow speed to clear deep or hard packed
snow.
DO NOT transport machine while engine is
running.
Tips for Operation
Snow is best removed as soon as possible
after snow fall.
MAINTENANCE
Ariens Dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact an Ariens
dealer or an authorized engine manufacturer's
service center.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
SERVICE POSITION
WARNING: Before tipping unit up
onto housing, remove fuel so no
spills will occur. Ensure unit is
secure and will not tip over during
maintenance.
Place unit on a flat level surface. Tip unit
forward onto front of impeller housing for
service. Ensure unit is secure and will not tip
over. Strap and clamp onto bench if needed.
GB - 17
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 932037-724, Ariens 932038-5520, Ariens 932039-624, Ariens 932505-724, Ariens 932507-520, Ariens 932508-624 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)