2.
3.
4.
5.
Pull shift rod and adjustment pivot pin out
of speed selector lever.
ATTACHMENT DRIVE BELT
REPLACEMENT
Place the speed selector lever in the
fastest forward speed position.
Remove Attachment Drive Belt
(Figures 18 and 19)
Pull the shift rod straight down towards
the ground as far as it will go.
1. Shut off engine, remove key, disconnect
spark plug wire and allow unit to cool
completely.
Thread the adjustment pivot pin along the
shift rod until it aligns with the mating hole
on the speed selector lever.
2. Remove two screws securing belt cover
to unit and remove belt cover.
6.
7.
Reinsert the pivot pin into the hole on the
speed selector lever.
3. Remove spring pin from chute crank rod
assembly and separate (932037, 039,
505, 507, 508).
Check forward and reverse speeds.
a. Start unit.
4.
5.
6.
Remove hardware holding chute strap to
engine and lift discharge chute off
housing.
b. Shift speed selector into first forward
speed.
c. Engage traction clutch. Unit should
move forward.
Remove belt finger by removing cap
screw mounting belt finger to engine
(Figure 19).
d. Stop unit.
e. Shift speed selector into first reverse
speed.
Remove attachment drive belt from
engine sheave (it may be necessary to
turn engine sheave using recoil starter
handle).
f. Engage traction clutch. Unit should
move backward.
g. Shut off unit.
8.
9.
Adjust pivot pin as needed so unit travels
forward when speed selector lever is in
first forward position and backward when
speed selector lever is in first reverse
position.
CAUTION: Always support
Sno-Thro frame and housing when
loosening the cap screws holding
them together. Never loosen cap
screws while unit is in service
position.
Secure adjustment pivot pin to speed
selector lever with hairpin.
IMPORTANT: To avoid bending bottom cover,
when tipping unit apart, support handlebars
firmly or tip unit up on housing and remove
bottom cover by removing four cap screws
before separating unit.
3
7.
8.
Support Sno-Thro frame and housing.
Remove top two cap screws and loosen
lower cap screws holding blower housing
to frame (one on each side).
4
9.
Separate housing from unit. Lower
handlebar on floor.
10.
Remove attachment drive belt from lower
pulley (hold brake away from belt).
2
1
OSs0195
1.
2.
3.
4.
Shift Rod
Adjustment Pivot Pin
Speed Selector Lever
Hair Pin
Figure 17
GB - 21
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 932037-724, Ariens 932038-5520, Ariens 932039-624, Ariens 932505-724, Ariens 932507-520, Ariens 932508-624 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)