SERVICE AND MAINTENANCE
NOTE: If you’re replacing the friction wheel assembly as a whole,
discard the worn part and slide the new part onto the hex shaft.
Follow the steps above in reverse order to reassemble components. If
you’re disassembling the friction wheel and replacing only the rubber
ring, proceed as follows:
1
.
Remove the four screws which secure the friction wheel’s side
plates together. See Figure 32.
2
3
.
.
Remove the rubber ring from between the plates.
Reassemble the side plates with a new rubber ring.
NOTE: When reassembling the friction wheel assembly, make sure
that the rubber ring is centered and seated properly between the side
plates. Tighten each screw only one rotation before turning the wheel
clockwise and proceeding with the next screw. Repeat this process
several times to ensure the plates are secured with equal force
(between 6 ft-lbs and 9 ft-lbs).
4.
Slide the friction wheel assembly back onto the hex shaft and
follow the steps above in reverse order to reassemble
components.
Figure 32
5.
Perform the Drive Control Test outlined earlier in the Service and
Maintenance section.
maintenanCe sCHedULe
Warning
Before performing any type of maintenance/service, disengage all
controls and stop the engine. Wait until all moving parts have come to
a complete stop. Disconnect spark plug wire and ground it against the
engine to prevent unintended starting. Always wear safety glasses during
operation or while performing any adjustments or repairs.
Follow the maintenance schedule given below. This chart describes
service guidelines only. Use the Service Log column to keep track of
completed maintenance tasks. To locate the nearest Sears Service
Center or to schedule service, simply contact Sears at
1-800-4-MY-HOME®.
interval
EachhoursUse and every 5
item
service
service Log
1. Engine oil level
1.
Check
2.
Loose or missing hardware
Unit and engine.
2. Tighten or replace
3
.
3.
1.
1.
Clean
Change
Check
1st 5 hours
Annually or 25 hours
1. Engine oil
1. Spark plug
2
3
.
.
Control linkages and pivots
Wheels
2. Lube with light oil
3. Lube with multipurpose auto grease
4. Lube with light oil
4
.
Gear shaft and Auger shaft
Annually or 50 hours
Annually or 100 hours
Before Storage
1. Engine oil
1. Spark plug
1. Fuel system
1.
1.
Change
Change
1. Run engine until it stops from lack
of fuel
23
| Categories | Craftsman Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Craftsman 247.88955 |
| Model Number | 247.88955 |
| Model Year | 2005 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English, Español |
| Product Name | Craftsman 24-Inch Snow Thrower |
| Product Brand | Craftsman. Customer Service Representatives are available by phone: Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower |
| Product Type | Snowthrower |
| Swath | 24 inch |
| Engine Manufacturer | Craftsman |
| Engine Oil Type | SAE 5W30, 4-Cycle Engine Oil (Quart) Recommended for Temperature: - Above 32°F: SAE 30W Straight Grade; - 0°F to 32°F: SAE 5W-30 or SAE 10W-30 Multi Grade; - Below O°F: SAE 0W-30 Synthetic |
| Engine Motor Model # | ZS365-SUA |
| Document File Type | |
| Publisher | craftsman.com |
| Wikipedia's Page | Craftsman (tools) |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)