3
Snow
Thrower
Setup
WARNING: Disconnect the spark plug
wire and ground it against the engine to
prevent unintended starting.
1
Positioning the Upper Handle
Remove packing material, if present.
1.
2.
Raise the upper handle in the direction shown in
Figure 1 until it clicks into the operating position.
Make sure not to pinch or crimp the cable.
2
3.
Tighten the knobs.
Figure 1
Assembling the Discharge Chute
NOTE: This Operator’s
Manual covers several
models.
For shipping reasons, the snow thrower has been
packaged with the upper chute pivoted all the way down.
To pivot it upward, proceed as follows:
2
Not all features refer-
enced in this manual
are applicable to all
snow thrower models.
1.
2.
3.
Turnstraighttheahead.chute until the chute opening is facing
Removechute. SeetheFigureknob and2. carriage bolt from the lower
Pivot the upper chute upward over the lip on the lower
chute so that there is NO gap between the upper
chute and the lower chute.
3
1
4. Re-secure with the hardware just removed. If installed
correctly, your snow thrower should look like Figure 3.
NOTE: All references
to left or right side of
the snow thrower is
from the operating
position only.
IMPORTANT: Do not use the chute handle to lift the
snow thrower
Figure
IMPORTANT:
Do not use the
chute handle to lift
the snow thrower.
Figure 3
6
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)