ASSEMBLY INSTRUCTIONS
KNOW YOUR TRIMMER
INSTALLING AND ADJUSTING THE D-HANDLE
Install
Spark Arrestor
Spark
Plug
Muffler
Muffler Cover
1.
Remove the screws and bottom clamp piece that were
installed on the D-handle for shipping.
2.
Place D-handle the over the shaft housing and onto the
bottom clamp (Fig. 1). Place it a minimum of 6 inches
Starter Rope Handle
Shaft Grip
(15.24
cm) from the end of the shaft grip.
On/Off Stop Control
Fuel Cap
On/Off Stop Control
(4)
Screws
Shaft
Housing
D-Handle
Throttle
Control
Spark Plug
Shaft Grip
Minimum 6 Inches
Air Filter
Cover
(15.24
cm)
Line
Cutting
Blade
D-Handle
EZ-Link®
Bottom Clamp
Shift
Handle
Fig. 1
Cutting
Primer
Bulb
3.
Start screws with a large Flat-head or T-25 Torx screwdriver.
Do not tighten until you make the handle adjustment.
Attachment
Shield
Adjust
4.
If the D-handle was pre-installed, loosen the screws on the
handle just enough to move it.
5.
While holding the unit in the operating position (Fig. 12, p. 7),
manuever the D-handle to the location that provides you the
best grip.
Blower
Cutting Head
Oil Plug
6.
Tighten the clamp screws evenly, until the D-handle is secure.
INSTALLING TRIMMER / BLOWER ATTACHMENT
NOTE:
To make installation easier, place the unit on the
SELECTING THE TRIMMER OR BLOWER
ground or on a workbench.
To switch between the trimmer and blower functions of this
unit, make sure that the unit is turned off and the engine has
stopped running.
1.
2.
Turn knob counterclockwise to loosen coupler (Fig. 20).
While firmly holding trimmer attachment, push it straight
into the coupler until the release button snaps into the
primary hole (Fig. 21).
WARNING: To avoid serious personal injury or
damage to the unit, DO NOT attempt to shift between
the trimmer and the blower while the unit is operating.
NOTE:
Aligning the release button with the guide recess will
help installation.
Turn the knob clockwise to tighten.
APPLICATIONS
Use the trimmer to cut grass and light weeds, and decorative
trimming around trees, fences, etc.
Use the blower to clean around buildings, walls, and fences
(Figs. 7 & 8), and around trees, shrubs, and flower beds (Fig. 9).
To Use the Trimmer
To use the trimmer, make sure the shift handle is in the DOWN
position before starting the unit.
3.
•
1.
If the shift handle is in the UP
position, grasp the red shift
latch (Fig. 3) on the shift
handle and squeeze until the
internal locking mechanism
releases.
•
INSTALLING CUTTING ATTACHMENT SHIELD
1.
2.
3.
Place the narrow end of the cutting attachment shield over
the shield bracket at the back of the attachment body and
position it so that the circular cut-out slips over the guard
assembly peg (Fig. 2).
Place the locking nut
Shift Latch
2.
Push the shift handle DOWN
until the red shift latch locks
into place. DO NOT FORCE.
Guard
Assembly
3. Start the unit following the
Starting Instructions (p. 6) and
the unit is ready for use.
into the hexagonal hole
Peg
on the left side of the
guard and hold in place.
Insert the assembly
screw into the hole on
the right side of the
guard and screw it
into the nut on the left
side using a Phillips-
head screwdriver.
Make sure the screw
is tight before
To Use the Blower
Shift Handle
Fig. 3
To use the blower, make sure the
shift handle is in the UP position
before starting the unit.
1.
If the shift handle is in the DOWN position, grasp the red shift
latch (Fig. 3) on the shift handle and squeeze until the internal
locking mechanism releases.
Shield
Bracket
2. Pull the shift handle UP until the red shift latch locks into
place. DO NOT FORCE.
3. Start the unit following the Starting Instructions (p. 6) and the
unit is ready for use.
4.
operating the unit.
Fig. 2
4
Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals |
---|---|
Tags | MTD TB26TB, Troy-Bilt TB26TB |
Download File |
|
Document Type | Owner's Manual |
Language | English |
Product Brand | MTD, Lawn Mower |
Document File Type | |
Publisher | mtdproducts.com |
Wikipedia's Page | MTD Products |
Copyright | Attribution Non-commercial |
(1 votes, average: 3 out of 3) Lawn and Garden readers have rated MTD Troy-Bilt TB26TB 4 Cycle Trimmer Lawn Mower Owners Manual 3.0 out of 3.0 based on 1 product reviews.