Xh
vt
D
hhqwr
ventilated locations. Ensure proper venti-
lation when working in trenches or other
confined areas.
Even an oil mist (from chain lubrication)
and sawdust are health hazards.
Be sure that the guide bar and chain are
clear of you and all other obstructions
and objects, including the ground. When
the engine is started, the engine speed
with the starting throttle lock engaged
will be fast enough for the clutch to
engage the sprocket and, if the chain-
brake is not activated, turn the chain.
If the upper quadrant of the tip of the bar
touches any object, it may cause kick-
back to occur (see section on reactive
forces). Never attempt to start the chain-
saw when the guide bar is in a cut or
kerf.
Xh
vt
To reduce the risk of personal injury
from loss of control or contact with the
running chain, do not use a saw with
incorrect idle adjustment. At correct idle
speed, the chain should not rotate. For
directions to adjust idle speed, see the
appropriate section of your owner’s
manual. If you cannot set the correct idle
speed, have your STIHL dealer check
your saw and make proper adjustments
or repairs.
After adjusting a chain, start the saw, let
the engine run for a while, then switch
engine off and recheck chain tension.
Proper chain tension is very important at
all times.
The muffler and other parts of the engine
(e.g. fins of the cylinder, spark plug)
become hot during operation and remain
hot for a while after stopping the engine.
To reduce risk of burns do not touch the
muffler and other parts while they are
hot. Operate the saw under good
visibility and daylight conditions only.
Don’t work alone. Keep within calling
distance of others in case help is
needed.
Xh
vt
On "QS" models, as soon as you press
down the interlock lever, the chain brake
is disengaged and allows the chain to
run at high speed until you blip the
throttle trigger and release the interlock
lever again.
Your chainsaw is equipped with a chain
catcher. It is designed to reduce the risk
of personal injury in the event of a thrown
or broken chain. From time to time the
catcher may be damaged or removed.
To reduce the risk of personal injury,
do not operate a chainsaw with a
damaged or missing catcher.
Inspect buffers periodically. Replace
damaged, broken or excessively worn
buffers immediately, since they may
result in loss of control of the saw.
A "sponginess" in the feel of the saw,
increased vibration or increased
"bottoming" during normal operation
may indicate damage, breakage or
excessive wear. Buffers should always
be replaced in sets. If you have any
questions as to whether the buffers
should be replaced, consult your STIHL
servicing dealer.
X
xvt8qvv
Operate the chainsaw under good
visibility and daylight conditions only.
Xh
vt
When you pull the starter grip, do not
wrap the starting rope around your
hands. Do not allow the grip to snap
back, but guide the starter rope slowly
back to permit the rope to rewind pro-
perly. Failure to follow this procedure
may result in injury to hand or fingers
and may damage the starter mechanism.
Xh
vt
Your chainsaw produces
poisonous exhaust fumes
as soon as the combusti-
ble engine is running.
These gases (e.g. carbon
monoxide) may be colorless and odor-
less.
To reduce the risk of serious or fatal
injury from breathing toxic fumes, never
run the chainsaw indoors or in poorly
| Categories | Chainsaw Manuals, STIHL Chainsaw Manuals |
|---|---|
| Tags | STIHL 036 QS |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Chainsaw |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)