English
Models without ElastoStart and
models with Easy2Start
Installing the rope rotor
Models with standard starter
a
7 8
9
N
Thread the new rope through the
starter grip and tie a simple
overhand knot. Dimension "a"
should be about 0.16 in (4 mm) to
0.23
in (7 mm).
N
N
Coat rope rotor bearing bore with
non-resinous oil.
N
N
Pull the knot back into the grip.
Refit the cap in the grip.
Slip the rotor over the starter post –
turn it back and forth to engage the
anchor loop of the rewind spring.
N
N
Refit the pawl (9) in the rotor.
Fit the washer (8) on the starter
post.
N
N
Remove the remaining rope from
the rotor and grip.
N
Use a screwdriver or suitable pliers
to install the spring clip (7) on the
starter post and engage it on the
pawl's peg – the spring clip must
point clockwise as shown in the
illustration.
Thread the new starter rope through
the rotor and secure it with a simple
overhand knot.
11
N
Thread the other end of the rope
through the rope guide bushing
(from inside) and the underside of
the starter grip and secure it with
one of the special knots shown – do
not wind the rope onto the rotor.
12
Thread the end of the rope
N
through the top of the guide
bushing (11) and rope rotor (12)
and secure it with a simple
overhand knot.
N
Go to "Installing the Rope Rotor".
4
2
MS 171, MS 181, MS 181 C, MS 211, MS 211 C
| Categories | Chainsaw Manuals, STIHL Chainsaw Manuals |
|---|---|
| Tags | STIHL MS 171, STIHL MS 181, STIHL MS 211 |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Chainsaw |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)