English / USA
D
D
Open-face technique
Making sapwood cuts
D = Felling cut
Conventional and open-face technique:
C = felling notch - determines the
direction of the fall
:
For medium sized or larger trees
make cuts at both sides of the trunk,
at same height as subsequent
felling cut.
:
:
:
:
Begin 1 to 2 inches (2,5 to 5 cm)
higher than center of felling notch.
For an open-face cut:
:
Properly place felling notch
perpendicular to the line of fall,
close to the ground.
Cut horizontally towards the felling
notch.
:
Cut to no more than width of guide
bar.
Leave approx.1/10 of diameter
uncut. This is the hinge.
This is especially important in softwood
in summer - it helps prevent sapwood
splintering when the tree falls.
:
Cut down at approx. 50-degree
angle to a depth of approx.1/5 to
Do not cut through the hinge - you
could lose control of the direction of
the fall.
1/4
of the trunk diameter.
:
:
Make second cut from below at
approx. 40 degree angle.
Remove resulting 90-degree piece.
20
MS 460, MS 460 R
Categories | Chainsaw Manuals, STIHL Chainsaw Manuals |
---|---|
Tags | STIHL MS 460 |
Download File |
|
Language | English, EspanĚol |
Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Chainsaw |
Document File Type | |
Publisher | stihl.com |
Wikipedia's Page | Stihl |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)