English
Tensioning the Chain
Check Chain Tension
3
1 1
2
4
1
N
N
Fit the guide bar over the studs (1) –
the cutting edges on the top of the
bar must point to the right.
Engage the peg of the tensioner
slide in the locating hole (2) –- place
the chain over sprocket (3) at the
same time.
Retensioning during cutting work:
N
Shut off the engine.
N
N
N
N
Shut off the engine.
Loosen the nuts.
N
Wear work gloves to protect your
hands.
N
The chain must fit snugly against
the underside of the bar and it must
still be possible to pull the chain
along the bar by hand.
N
Turn the tensioning
Hold the bar nose up.
screw (4)clockwise until there is
very little chain sag on the
underside of the bar – and the drive
link tangs are engaged in the bar
groove.
Use a screwdriver to turn the
tensioning screw (1) clockwise until
the chain fits snugly against the
underside of the bar.
N
If necessary, retension the chain.
A new chain has to be retensioned more
often than one that has been in use for
some time.
N
N
While still holding the bar nose up,
tighten down the nuts firmly.
N
N
Refit the sprocket cover and screw
on the nuts only fingertight.
Go to "Checking Chain Tension".
N
Check chain tension frequently –
see chapter on "Operating
Instructions".
Go to chapter on "Tensioning the
Saw Chain"
A new chain has to be retensioned more
often than one that has been in use for
some time.
N
Check chain tension frequently –
see chapter on "Operating
Instructions".
2
4
MS 880
| Categories | Chainsaw Manuals, STIHL Chainsaw Manuals |
|---|---|
| Tags | STIHL MS 880 |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Chainsaw |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)