BELT REMOVAL AND REPLACEMENT
6. Unhook the idler spring from the hex bolt on the
auger housing. See Figure 27.
WARNING: Disconnect the spark
plug wire from the spark plug and
ground.
7.
Back out the stop bolt to allow the belts to slip
between the bolt and auger pulley. See Figure
28.
AUGER BELTS
NOTE: It may be necessary to loosen the six hex
nuts that fasten the frame to the auger housing to aid
in belt removal.
NOTE: It is necessary to remove both belts in
order to change either one. If changing just one belt,
be certain to check the condition of the other belt
(model 600/610E has only one auger belt).
8.
Lift the rear auger belt from the auger pulley, and
slip belt between the support bracket and the
auger pulley. See Figure 27. Repeat this step for
front auger belt (except models 600/610E).
1.
Remove the plastic belt cover on the front of the
engine by removing the two self-tapping screws.
See Figure 25.
9.
Replace both auger drive belts by following
instructions in reverse order.
DRIVE BELT
1.
2.
Follow steps 1 through 4 of previous instructions.
Pull idler pulley up, and lift belt off engine pulley
and friction wheel disc. SeeFigure 26
3.
4.
Back out the stop bolt until the support bracket
rests on the auger pulley. See Figure 28.
Self-Tapping
Screws
Belt
Cover
Slip belt between friction wheel and friction
wheel disc. See Figure 28. Remove and replace
belt. Reassemble following the instructions in
reverse order.
NOTE: The support bracket must rest on the stop
bolt after the new belt has been assembled. See Fig-
ure 28.
Figure 25
2.
3.
4.
5.
Drain the gasoline from the snow thrower, or
place a piece of plastic under the gas cap.
Tip the snow thrower up and forward so that it
rests on the housing.
Friction
Wheel
Remove six self-tapping screws from the frame
cover underneath the snow thrower.
Roll the front and rear auger belts off the engine
pulley. See Figure 26.
Drive
Rear
Belt
Engine
Pulley
Auger
Belt
Support
Bracket
Front
Auger
Belt
Frame
Rear
Auger
Belt
Idler
Pulley
Front
Auger
Pulley
Support
Auger
Pulley
Idler
Auger
Idler
Spring Housing Bracket
Spring
Pulley
Engine
Pulley
Figure 27
Figure 26
16
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Machines Snow Blower Manuals |
|---|---|
| Tags | MTD E600E, MTD E610E, MTD E640F, MTD E660G, MTD Snow Blower Manual, Yard Machines E600E, Yard Machines E610E, Yard Machines E640F, Yard Machines E660G |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Yard Machines, E600E, E610E, E640F, E660G, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)