Auger
Drive
Clutch
Auger
Drive
Clutch
Traction Drive
Clutch
Traction
Drive
Clutch
Shift
Lever
Shift
Lever
Chute
Crank
Chute
Crank
Figure 22
Figure 23
SECTION 7: OPERATION
BEFORE STARTING
WARNING: Observe
Labels on the snow thrower prior to
use. See Figure 1.
all
Warning
Metal Loop
on Spark
Plug Wire
Your snow thrower is shipped with oil; however,
you must check the oil level before operating.
Be careful not to overfill.
Rubber Boot
Figure 24
3.
4.
Make certain the auger and drive clutch levers
are in the disengaged (released) position.
The spark plug wire was disconnected for safety.
Attach spark plug wire to spark plug before starting
Move throttle control up to FAST position. Insert
ignition key into slot. See Figure 21. Be certain
it snaps into place. Do not turn key.
GAS AND OIL FILL-UP
Check oil level and add oil if necessary. Service the
engine with gasoline as instructed in the separate
engine manual packed with your snow thrower.
Read instructions carefully.
ENGINE WILL NOT START
UNLESS IGNITION KEY IS IN-
SERTED
SLOT
INTO
CARBURETOR
IGNITION
IN
WARNING: Never
fill
fuel
tank
COVER. DO NOT TURN IGNI-
TION KEY.
indoors, with engine running or while
engine is hot. Do not smoke when
filling fuel tank.
Electric Starter:
TO START ENGINE
WARNING: The
equipped with a three-wire power cord
and plug, and is designed to operate on
electric
starter
is
NOTE: If unit shows any sign of motion (drive or
augers) with the clutch grips disengaged, shut
engine off immediately. Readjust as instructed in
the Final Adjustments section of SECTION 5:
ASSEMBLY INSTRUCTIONS.
120
volt AC household current. It must
be properly grounded at all times to
avoid the possibility of electric shock
which may be injurious to the operator.
Follow all instructions carefully. If the
house wiring system is not a three-wire
grounded system, do not use this
electric starter under any conditions.
1.
Attach spark plug wire to spark plug. Make
certain the metal loop on end of the spark plug
wire (inside the boot) is fastened securely over
the metal tip on the spark plug. See Figure 24.
2.
Make certain the fuel cutoff valve is in the
OPEN (vertical) position. See Figure 20.
12
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Machines Snow Blower Manuals |
|---|---|
| Tags | MTD 614E, MTD E642E, MTD E644E, MTD E662H, MTD E664F, MTD Snow Blower Manual, Yard Machines 614E, Yard Machines E642E, Yard Machines E644E, Yard Machines E662H, Yard Machines E664F |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Yard Machines, 614E, E642E, E644E, E662H, E664F, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)