Yard Machines E642E E662H 614E E644E E664F Snow Blower Owners Manual by MTD

AUGER BELTS
5.   Roll  the front and rear auger belts off  the engine
pulley. See Figure 30.
NOTE: It  is   necessary  to  remove   both  belts  in
order to change either one. If  changing just one belt,
be certain to check the condition of the other belt.
6.
Unhook the idler  spring from the hex bolt  on the
auger housing. See Figure 31.
7.
Back out  the stop  bolt to  allow the  belts to  slip
between the bolt and auger pulley.
See Figure 32.
1.
Remove the plastic belt  cover on the front of the
engine
by
removing
the
two
self-tapping
screws. See Figure 29.
8.
9.
Lift  the  rear auger  belt  from  the  auger  pulley,
and  slip belt  between  the  support bracket  and
the  auger  pulley.  See  Figure  31.  Repeat  this
step for front auger belt.
2.
3.
Drain  the  gasoline  from  the  snow  thrower,  or
place a piece of plastic under the gas cap.
Tip the  snow thrower  up  and forward  so that  it
rests on the auger housing.
Replace  both   auger  drive   belts   by  following
instructions in reverse order.
DRIVE BELT
1.
Follow
steps
1
through
4
of
previous
instructions.
2.
Pull  idler   pulley   up,  and   lift  belt   off  engine
pulley, idler pulley, and friction wheel disc.
See Figure 30.
Self-Tapping
Screws
Belt
Cover
3.
4.
Back out  the stop  bolt until  the support  bracket
rests on the auger pulley. See Figure 32.
Slip   belt  between   friction  wheel   and   friction
wheel disc. See Figure  31. Remove and replace
belt.  Reassemble  following  the   instructions  in
reverse order.
NOTE: The  support bracket must  rest on  the stop
bolt  after  the  new  belt has  been  assembled.  See
Figure 32.
Figure 29
4.
Remove six  self-tapping screws  from the  frame
cover underneath the snow thrower.
Friction
Wheel
Drive
Rear
Belt
Auger
Belt
Engine
Pulley
Front
Auger
Belt
Support
Bracket
Rear
Auger
Belt
Frame
Engine
Pulley
Idler
Pulley
Idler
Pulley
Front
Auger
Pulley
Support
Bracket
Spring
Figure 30
Auger
Pulley
Auger
Housing
Idler
Spring
NOTE: It  may be necessary  to loosen  the six  hex
nuts  that fasten  the frame  to  the auger  housing  to
aid in belt removal.
Figure 31
17
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals, Yard Machines Snow Blower Manuals
Tags, , , , , , , , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandYard Machines, 614E, E642E, E644E, E662H, E664F, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website