SECTION 5: ASSEMBLY INSTRUCTIONS
IMPORTANT: After
with gasoline, and check oil level as instructed in the
separate engine manual packed with your unit.
assembly,
service
engine
Attaching the Handle Assembly.
(Hardware A and E)
Lay loose parts out on flat surface.
NOTE: All references to right or left side of the
snow thrower are determined from behind the unit
in the operating position.
1. Handle Panel
5. Traction Drive Control
Grip
2.
3.
Right Handle
Left Handle
6.
7.
Right Grip Bracket
Left Grip Bracket
UNPACKING
4. Auger Control Grip
1.
Remove staples or break glue on the top flaps of
the
carton. Remove any loose parts like
1
operator’s manual or hardware pack included
with unit.
2.
3.
4.
5.
Cut along dotted lines and lay end of carton
down flat. Remove packing material.
Roll unit out of carton. Check carton thoroughly
for loose parts.
7
6
5
4
Extend cables out behind unit and lay them on
the floor.
Lay out the contents of the hardware pack
according to the illustration on page 5 and
identify each part.
2
3
6.
Find the loose parts in the carton and lay these
on the floor. You should locate the following
loose parts in the carton:
Figure 3
1.
Attach left handle and grip bracket to handle
panel with two carriage bolts, lock washers and
hex nuts. (Be sure the bend in the grip bracket is
towards the center of the handle panel. (See
Figure 4.) Do not tighten at this time.
1
2
3
4
5.
6.
7.
8.
9.
10.
11.
.
Handle Panel
Right Handle
Left Handle
Auger Control Grip
Traction Drive Control Grip
Right Clutch Grip Bracket
Left Clutch Grip Bracket
Shift Rod (Not Illustrated)
Chute Crank Assembly (Not Illustrated)
Chute Assembly (Not Illustrated)
Hardware Pack (Not Illustrated)
.
.
.
Handle Panel
Outer
Edge
of Handle
Panel
Left Grip Bracket
Tools Required
Carriage
Bolts
The snow thrower comes partly assembled in the
carton. You will have to complete the assembly.
Follow assembly instructions in this operator’s
manual to make the job safe and easy. You will
need the following tools to assemble the snow
thrower.
Left Handle
(curves in)
Lock Washers
A.
B.
Set of Wrenches (3/8", 9/16", 1/2" or
adjustable)
Pair of pliers
Figure 4
2.
Locate auger control grip, part #4 in Figure 3.
The triangular metal tab on the auger control
grip must face the center of the handle panel.
(Hardware D)
6
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Machines Snow Blower Manuals |
|---|---|
| Tags | MTD 614E, MTD E642E, MTD E644E, MTD E662H, MTD E664F, MTD Snow Blower Manual, Yard Machines 614E, Yard Machines E642E, Yard Machines E644E, Yard Machines E662H, Yard Machines E664F |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Yard Machines, 614E, E642E, E644E, E662H, E664F, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)