Throttle
Discharge Chute
The throttle controls the engine speed. To
increase or decrease the engine speed,
adjust to:
Discharge chute rotates 200°.
1
2
ALWAYS position discharge chute in safe direction and
angle, away from operator and bystanders, before
starting engine.
1. Fast (normal or warm starts)
2. Part-Throttle
3
Discharge Chute Control
4
OL2720
3. Slow
IMPORTANT: If chute does not stay in set position,
adjust as directed in SERVICE AND ADJUSTMENTS
on page 23, or repair before operation.
STOP
4. Stop (engine is off) (Not on 12V models)
Electric Starter
Rotate the Chute with Discharge Chute Control.
The electric starter will start a properly choked and
cranked engine when the key is turned (12V) or starter
button (120V or 240V) is pushed. Refer to Starting and
Shut Off on page 17.
Recoil Starter Handle
When pulled, handle will turn engine over.
IMPORTANT: DO NOT let handle snap back against
starter.
Snow Clean-Out Tool (Figure 11)
WARNING: Hand contact with the rotating
impeller is the most common cause of injury
associated with snow throwers. Never use
your hand to clean out the discharge chute.
Figure 12
OS7105
IMPORTANT: DO NOT force frozen chute controls. If
still frozen, take to warm place until controls are free.
1
Heated Handles (926002, 003, 004, 005, 006,
102, 103, 300, 301, 302, 303, 304, 500, 501)
Turn the heated handles switch to the
ON (1) position to activate. Turn the
switch to the OFF (2) position to
1
deactivate.
2
OS1950
Remote Differential (926004, 005, 006, 300,
301, 500, 501)
Squeeze and hold the remote differential lever to lock
differential so both wheels drive and provide better
traction. Release the remote differential lever to allow
easier steering.
Figure 11
OS7100
To clear the chute:
1.
2.
Shut off the engine.
If remote differential does not engage or disengage
properly, adjust or repair before operation (see
REMOTE DIFFERENTIAL (926004, 005, 006, 300,
Wait 10 seconds and make sure impeller blades
have stopped rotating.
3.
4.
Remove the snow clean-out tool (1) from the
auger housing and use it to remove the clog.
301, 500, 501)
on page 24).
Remote Wheel Lock (926002, 003, 102, 103,
302, 303, 304)
Replace the snow clean-out tool on the auger
housing.
Squeeze and release the remote wheel lock to lock the
left wheel for better traction when throwing snow or to
unlock the left wheel for easier steering.
Deflector Remote
Place deflector into position before operation. DO NOT
throw snow any higher than necessary.
NOTE: The wheel lock will not release when under
load. Do not unlock the wheel while turning. If the
wheel lock will not release, turn the unit slightly left or
right to relieve axle load and release the axle lock.
Place deflector remote in a forward notch to throw
snow lower. Place deflector remote in a rearward notch
to throw snow higher.
GB - 15
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 926001, Ariens 926002, Ariens 926003, Ariens 926004, Ariens 926005, Ariens 926006, Ariens 926007, Ariens 926008, Ariens 926009, Ariens 926010, Ariens 926011, Ariens 926012, Ariens 926101, Ariens 926102, Ariens 926103, Ariens 926300, Ariens 926301, Ariens 926302, Ariens 926303, Ariens 926304, Ariens 926500, Ariens 926501, Ariens 926504 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)