SERVICE AND ADJUSTMENTS
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
1
RUNNERS
Runners should be adjusted as conditions require
(Figure 19).
1.
2.
Position unit on a hard, flat, smooth level surface.
2
Adjust runners by inserting a spacer of desired
thickness under center of scraper blade, loosen
runner hardware, slide runners to flat surface.
Allow 1/8 in. (3 mm) between scraper blade and
hard smooth surfaces. Allow 1-1/4 in. (30 mm)
between scraper blade and uneven or gravel
surfaces. Retighten hardware.
2
1.
2.
Auger
Shear Bolts
Figure 20
OS7150
NOTE: Keep housing level by adjusting runners
equally.
For Replacement:
1.
2.
3.
Align shear bolt holes in auger with shear bolt
holes in the shaft.
Drive shear bolt through hole (if shear bolt was
broken this will drive remaining part from shaft).
Secure shear bolt with nut.
2
HANDLEBAR HEIGHT
1
1.
2.
Runner
Runner Hardware
CAUTION: AVOID INJURY. Adjust the
attachment clutch, speed selector and
traction clutch after changing the handlebar
height. See Attachment Clutch/Brake
Adjustment on page 26, Speed Selector
Adjustment on page 26 and Traction Drive
Clutch Adjustment on page 28.
OS0482
Figure 19
SCRAPER BLADE
IMPORTANT: Damage to auger/impeller housing will
result if blade wears down too far.
To raise or lower the handlebar:
Scraper blade is adjustable to compensate for wear.
To adjust scraper blade:
1.
Remove hair pin holding chute rod to control
assembly.
1.
2.
3.
Tip unit back onto handlebar, support housing
and loosen nuts retaining blade.
2. Place unit in service position (see Service
Position on page 20).
Adjust runners to fully raised position (housing
closest to ground).
3. Remove bottom cover.
4.
Remove top mounting bolts from the handlebars
and adjust the handlebar up or down as needed
until the handlebar mounting holes align with
holes in unit frame.
Reposition scraper blade flush with runners and
tighten lock nuts.
SHEAR BOLTS
5.
Secure handlebar to frame with hardware
removed in step 4 using the different hardware
locations shown in Figure 21.
IMPORTANT: Use only Ariens shear bolts for
replacement. Use of any other type of shear bolt may
result in severe damage to unit.
Occasionally a foreign object may enter the
auger/impeller housing and jam the auger, breaking
shear bolts (Figure 20) which secure the auger to the
shaft. This allows auger to turn freely on the shaft
preventing damage to gear drive.
GB - 23
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 926001, Ariens 926002, Ariens 926003, Ariens 926004, Ariens 926005, Ariens 926006, Ariens 926007, Ariens 926008, Ariens 926009, Ariens 926010, Ariens 926011, Ariens 926012, Ariens 926101, Ariens 926102, Ariens 926103, Ariens 926300, Ariens 926301, Ariens 926302, Ariens 926303, Ariens 926304, Ariens 926500, Ariens 926501, Ariens 926504 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)