NOTE: When temperature is below -15° F (-26° C)
additional priming may be needed.
12. Set throttle to Part Throttle or Slow position for
travel or adaptation to outside temperature. Set
throttle to Fast position for normal operation. (All
models except 926007)
4.
If engine is cold, apply choke. See Engine
Manual for detailed instructions.
NOTE: A warm engine requires less choking than a
Electric Start (12V)
cold engine.
1.
2.
Turn discharge chute straight ahead.
5.
6.
Set throttle to proper starting position.
Insert key into ignition switch.
Make sure that the traction clutch and attachment
drive clutch levers are fully disengaged.
12V - Turn key to RUN position.
3. Push Primer Bulb 2 or 3 times for cold engine.
120V or 240V - Push key into RUN position. DO
NOT twist key after it is inserted.
NOTE: When temperature is below -15° F (-26° C)
additional priming may be needed.
7.
8.
Grasp starter handle and pull rope out slowly until
it pulls harder. Let rope rewind slowly.
4. If engine is cold, apply choke. See Engine
Manual for detailed instructions.
Pull rope with a rapid continuous full arm stroke.
Let rope rewind slowly.
NOTE: A warm engine requires less choking than a
cold engine.
IMPORTANT: DO NOT let Starter Handle snap against
5. Set throttle to proper starting position.
Starter.
6.
Turn ignition key to the START position until
engine starts and release into the RUN position.
9.
Repeat steps 7 and 8 until engine starts. (If
engine does not start, refer to
IMPORTANT: DO NOT operate starter more than 15
seconds per minute, as overheating and damage can
occur. (If engine does not start, refer to
TROUBLESHOOTING on page 59.)
10.
11.
Adjust choke as needed.
TROUBLESHOOTING on page 59.)
Set throttle to Part Throttle or Slow position for
adaptation to outside temperature or travel. Set
throttle to Fast position for normal operation.
7. Adjust choke as needed.
8.
Set throttle to Part Throttle or Slow position for
travel or adaptation to outside temperature. Once
achieved, set throttle to Fast position for normal
operation.
Electric Start (120V or 240V)
1.
Connect extension cord to starter.
IMPORTANT: Prevent damage to unit. Know voltage of
your starter and only use matching outlets.
Shut Off
1.
2.
3.
4.
Release Traction Drive Clutch Lever and allow
unit to come to a complete stop.
2.
Plug extension into 120V or 240V 3-wire,
grounded outlet.
Run Impeller a few minutes after use to prevent
freeze-up of Impeller.
3.
4.
Turn discharge chute straight ahead.
Make sure that the traction clutch and attachment
drive clutch levers are fully disengaged.
Release Attachment Clutch Lever and wait for all
moving parts to come to a complete stop.
5.
Push Primer Bulb 2 or 3 times for cold engine.
Move Throttle to the “Stop” position. (All models
except 926007)
NOTE: When temperature is below -15° F (-26° C)
additional priming may be needed.
5.
6.
Turn engine shut-off switch "OFF". (926007)
Remove key.
6.
Insert key into ignition switch on engine and push
into "Run" position. DO NOT twist key after it is
inserted.
SNOW REMOVAL
7.
If engine is cold, apply choke. A warm engine
requires less choking than a cold engine. See
Engine Manual for detailed instructions.
IMPORTANT: Allow unit and engine to adjust to the
outdoor temperature before clearing snow.
NOTE: Attachment clutch should be engaged before
wheel drive clutch when throwing snow.
8.
9.
Set throttle to proper starting position.(All models
except 926007)
1.
2.
Select Speed Control position and direction.
Engage Attachment Clutch - Right Hand Lever.
Press starter button on engine until engine starts.
IMPORTANT: DO NOT operate starter more than 15
seconds per minute, as overheating and damage can
occur. (If engine does not start, refer to
3. Engage Traction Drive Clutch - Left Hand Lever.
IMPORTANT: DO NOT overload unit capacity by
attempting to clear snow at too fast a rate. Use slow
speed to clear deep or hard packed snow.
TROUBLESHOOTING on page 59.)
10.
11.
Adjust choke as needed.
Disconnect power cord from outlet, then starter.
GB - 18
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 926001, Ariens 926002, Ariens 926003, Ariens 926004, Ariens 926005, Ariens 926006, Ariens 926007, Ariens 926008, Ariens 926009, Ariens 926010, Ariens 926011, Ariens 926012, Ariens 926101, Ariens 926102, Ariens 926103, Ariens 926300, Ariens 926301, Ariens 926302, Ariens 926303, Ariens 926304, Ariens 926500, Ariens 926501, Ariens 926504 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)