PREPARING VEHICLE
Install Mounting Angles
G
H
C
A
B
I
D
J
M95930
M95932
8. Insert 3/8 x 1 1/4-Inch bolt (G) down through mower
mounting bracket of tractor (H), through 7/16-Inch jam nut
(I) used as spacer, through mounting angle, then secure
with 3/8-Inch Nylock nut (J).
1.
Assemble 1/2-Inch standard nut (A) onto 1/2 x 2-Inch
hex bolt (B) and run it down to the end of the treads.
2.
Lock the nut in place with two wrenches.
9.
Install a mounting angle to the other side of the tractor
using the same procedure as first mounting angle.
F
10.Tighten securely the finger tight bolt and nut at each
side of the front axle bracket.
Install Clutch Link Rod to Tractor
E
C
E
A
C
B
B
M95931
3.
Inch bolt into hole.
At the rear end of one mounting angle (C) insert 1/2 x 2-
A1
4.
5.
1/2-Inch
using same procedure as above.
Secure with 1/2-Inch lock nut (D).
1.
(15
Pre-adjust clutch link rod (A) to approximately 384 mm
In.) (A1) from the center of the bent end of the clutch
rod to the center of the adjustable anchor (B).
Install 1/2 x 2-Inch bolt with 1/2-Inch standard nut and
lock nut into same hole of other mounting angle
2.
the bend of the clutch rod and spread ends to secure.
Insert 1/8 x 1 1/4-Inch cotter pin (C) into hole nearest
6.
front axle bracket (F).
Insert 3/8 x 1-Inch bolt (E) through from the inside of the
7.
secure finger tight with 3/8-Inch Nylock nut.
Place mounting angle over end of 3/8 x 1-Inch bolt and
E
D
A
3.
Insert bent end of clutch link rod up into the hole in the
tractor attachment engagement lever (D). Secure with hair
Preparing Vehicle - 9
Categories | John Deere Snow Blower Manuals, Snow Blower Manuals |
---|---|
Tags | John Deere OMGX10742 J9 |
Download File |
|
Document Type | Owner's Manual |
Language | English |
Product Brand | John Deere, Snow Blower |
Document File Type | |
Publisher | deere.com |
Wikipedia's Page | John Deere |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)