SERVICE
Lubricate Auger
bolt (A).
B
B
B
A
C
A
Lubricate auger bearings (A), auger tubes (B), and
discharge fan (C) with General Purpose Grease.
M95959
•
Tighten lock nut (B) 1/8 turn and check rotation of
discharge chute drive tube by turning chute control rod.
Lubricate Discharge Chute
•
A small amount of resistance should be encountered.
DO NOT overtighten. Tighten until discharge chute holds
its position.
A
Chute Control Cable Hook-Up
Chute control cable is wound around discharge chute drive
tube 2 1/2 turns each way; both ends of equal length. This
will allow equal angle of discharge chute in both directions.
Replacing Upper V-Belt
1.
Remove the snowblower from the tractor, if necessary.
Lubricate discharge chute (A) with WD-40 or equivalent.
2. Remove damaged V-belt.
Adjusting Discharge Chute Drive Tube
c
CAUTION: Avoid injury! Rotating auger is
dangerous.
•
Park the machine safely and lock the park
brake before getting off the seat.
•
•
•
•
Turn the snowblower off.
Stop the engine.
3.
Install new V-belt on upper idlers as shown.
Wait for all moving parts to stop.
Disconnect spark plug wire(s) to prevent
engine from starting accidently.
If discharge chute will not hold its position and tends to
rotate, adjust lock nut on end of discharge chute tube eye
Service - 24
| Categories | John Deere Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | John Deere OMGX10742 J9 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | John Deere, Snow Blower |
| Document File Type | |
| Publisher | deere.com |
| Wikipedia's Page | John Deere |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)