ASSEMBLY
Assembling Snowblower
I
E
D
F
E
C
Picture Note: Underside of mounting frame shown
to illustrate correct routing of lower V-belt.
B
F
C
9. Install lower V-belt around mounting bracket idlers and
pulley (I) as shown.
A
IMPORTANT: Avoid damage! Route upper V-belt
INSIDE three belt guides. Routing belt incorrectly
can cause belt damage.
C
1.
handle (A) under the channel bracket (B).
Raise the rear of the snowblower and slide the lift
K
J
2.
Place spacer shims (C) inside the rear of the mounting
channel with the short end toward the front of the
snowblower and align holes.
M
3.
Slide mounting frame (D) inside channel bracket.
4.
Check that holes in spacer shims are aligned with holes
KL
in lower frame bar.
K
5.
Insert 5/16 x 1 3/4-Inch bolts (E), one on each side,
through vertical hole of the lower mounting frame bar,
spacer shim, and channel bracket and secure with 5/16-
Inch Nylock nuts. Do not tighten at this time.
10.Install
11.Check
upper V-belt (J) to idlers as shown.
belt routing. Make sure upper V-belt is routed
INSIDE two belt guides (K) and belt guide (L).
position of belt guide (L).
Tractors with V-Twin engines and 46-Inch mower
6.
Insert 5/16 x 1 3/4-Inch bolts (F), two on each side,
12.Check
through horizontal holes of channel bracket and lower
frame bar and secure with 5/16-Inch Nylock nuts. Tighten
nuts.
•
deck: Belt guide (L) should remain in outer hole as
shown.
7.
8.
Tighten nuts on vertical bolts.
•
All other tractors: Move belt guide (L) to inner hole
Raise the rear of the snowblower and remove the lift
(M).
handle from under it.
Assembly - 5
Categories | John Deere Snow Blower Manuals, Snow Blower Manuals |
---|---|
Tags | John Deere OMGX10742 J9 |
Download File |
|
Document Type | Owner's Manual |
Language | English |
Product Brand | John Deere, Snow Blower |
Document File Type | |
Publisher | deere.com |
Wikipedia's Page | John Deere |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)