MTD 2B5 295 E2B5 E295 Snow Blower Owners Manual

6
Replacing Belt
WARNING: Before servicing, repairing,
or inspecting, disengage the control
bail and stop engine. Wait until all
moving parts have come to a complete
stop. Disconnect spark plug wire and
ground it against the engine to prevent
unintended starting.
������������
Adjustments
&
Remove the belt cover by removing five hex screws. See
Figure9. Thensimplypull  thebelt off bygraspingit from
the bottom of the auger pulley and pulling off.  Once you
remove the belt from the pulleys, you can push down on
the idler pulley to release the belt from under belt keeper.
To replace the belt follow these instructions and refer to
Figure 10:
Maintenance
�����������
������
�������������������
1.
2.
3.
Push down on the Idler pulley.
Put belt on top of the auger pulley under belt keeper.
Thread belt around engine pulley.
Figure 9
WARNING
4.  Push belt over bottom of auger pulley.
Reinstall the belt cover removed earlier.
Beforeservicing,
repairing, orinspect-
ing, disengagethe
control bail andstop
engine. Wait until all
movingpartshave
cometoacomplete
stop. Disconnect
sparkplugwireand
groundit against the
enginetoprevent
Engine
1.
Refer to the separate engine manual for all engine
maintenance procedures.
2.
Check engine and snow thrower frequently for loose
hardware, and tighten as needed.
Lubrication
Lubricatepivot pointsonthecontrol  handleandthe
extension spring at the end of the control cable  with a
light oil once every season and before storage of the
snow thrower at the end of the season.
unintendedstarting.
Replacing Auger Paddles
The snow thrower auger’s rubber paddles are subject to
wear and should be replaced if any signs of excessive
wear is present.
Figure 10
IMPORTANT: Do NOT allow the auger’s rubber paddles
to wear to the point where portions of the metal auger
itself can come in contact with the pavement. Doing so
can result in serious damage to your snow thrower.
IMPORTANT: Do NOT
allow the auger’s rubber
paddles to wear to the point
where portions of the metal
auger itself can come in
contact with the pavement.
Doing so can result in
serious damage to your
snow thrower.
To change the rubber paddles, proceed as follows:
1.
Remove the existing rubber paddles by unthreading the
self-tapping screws which secure them to the auger.  
See Figure 11.
2.
Secure the replacement rubber paddles to the auger
using the hardware removed earlier.
Figure 11
11
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags, , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 32 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website