MTD Cub Cadet 1345 SWE 45-Inch Snow Blower Owners Manual

SECTION 7:  SERVICING YOUR SNOW THROWER
WARNING:  Before servicing, repairing,  or
inspecting,  disengage  all  clutch  levers  and
stop engine. Wait until all moving parts have
come  to  a complete  stop.  Disconnect spark
plug wire and ground it against the engine to
prevent unintended starting.
Remove the six carriage bolts (three per side),
belleville washers and hex nuts which attach slide
shoes to the snow thrower on two sides. See Figure 8
on page 7.
Reassemble new slide shoes with the hardware
removed earlier (cupped side of belleville washer
against the slide shoes). Make certain the slide
shoes are adjusted to be level.
To remove the shave plate, remove slide shoe as
well as the carriage bolts, belleville washers and
hex nuts which attach shave plate to the snow
thrower housing. For location of shave plate and
carriage bolts, see Figure 16.
Augers
The augers are secured to the spiral shaft with two
shear bolts and hex lock nuts. See Figure 16. If you hit
a foreign object or ice jam, the snow thrower is
designed so that the bolts may shear.
Reassemble the new shave plate, making sure
heads of carriage bolts are to the inside of the
housing.
Shear Bolts
Reinstall the skid shoes and tighten securely.
Replacing Belts
To remove and replace either the auger belt or the drive
belt, follow the steps below and then proceed to the
specific steps listed under respective sub-headings.
Hairpin
Clip
Flat
Belt Cover
Washers   Belt Cover Bolts(3)
Washer
Hex Nut
Carriage Bolt
Figure 16
Shave Plate
If the augers do not turn, check if the bolts have
sheared. Two replacement shear bolts and hex lock
nuts have been provided with the snow thrower. Refer
to Loose Parts on page 5. For future use, order the
parts numbers listed in Figure 1.
IMPORTANT: NEVER replace the auger shear bolts with
standard hex bolts. Any damage to the auger gearbox
or other components, as a result of doing so, will NOT
be covered by your snow throwers warranty.
Upper Bolt
(remove)
Support Tube Bolt
Shoulder Bolt
(do not remove)
Shave Plate and Skid Shoes
Figure 17
The shave plate and skid shoes on the bottom of the
snow thrower are subject to wear. They should be
checked periodically and replaced when necessary.
Disconnect the chute crank assembly at the
discharge chute end by removing the hairpin clip
and the two flat washers.
Remove the plastic belt cover, located near the
engine, by removing the three self-tapping screws
and flat washers that secure it. Refer to Figure 17.
Remove the large shoulder bolt and washer on the
left hand side of the engine pulley. Refer to Figure
18.
NOTE: The skid shoes on this machine have two wear
edges. When one side wears out, they can be rotated
180
° to use the other edge.
14
Product Specification
CategoriesCub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website