MTD Cub Cadet 1345 SWE 45-Inch Snow Blower Owners Manual

SECTION 2:  ASSEMBLING YOUR SNOW THROWER
Unpacking
Remove staples from the top, sides, and ends of
the shipping crate.
Set panels aside to avoid tire punctures or personal
injury.
Remove and discard plastic bag that covers unit.
Roll the unit out of the crate.
Check the crate thoroughly for loose parts before
discarding.
Upper Handle
Steering Cable
Tighten these
Wing Nuts
Loose Parts
Lower Handle
Cable Tie
The snow thrower is shipped with the following
loose parts in the carton. Refer to Figure 1 for
illustration, description of item, and part number.
Please remove all loose parts from the carton
before discarding it.  
Upper Shift Rod
Clutch Rod
Connector
Shear Bolts
(710-0891)
Carriage Bolt
Cupped Washer
Wing Nut
Upper Shift Rod
Hex Lock Nuts
(712-0429)
(Support Tubes Omitted for Clarity)
Figure 2
Raise the upper handle assembly in the direction
shown in Figure 3. Make sure that the upper handle
locks into position over the lower handle.
Figure 1
Note that these shear bolts and hex lock nuts are
not meant for initial assembly of the equipment. If
the snow thrower hits a foreign object or ice jam,
the bolts securing the auger shaft may shear. Use
these two shear bolts and nuts as replacement
parts only. Store these in a safe place until needed.
Handle Panel
Wing Nuts
IMPORTANT: NEVER replace the auger shear bolts with
standard hex bolts. Any damage to the auger gearbox
or other components from standard hex bolts will not be
covered by your snow throwers warranty.
Assembling Handle
Upper Handle
NOTE: Reference to the left or   right side of the snow
thrower in this manual is observed from the operator’s
position.
Lower Handle
Support Tube
IMPORTANT: Make any final adjustments, as instructed
later on in this section, before operating your snow
thrower. Failure to follow these instructions may cause
damage to the snow thrower.
Figure 3
Look at the lower rear of the snow thrower frame to
be sure all the cables are aligned with the cable
roller guides.
Secure the upper handle and lower handle with the
two plastic wing nuts, cupped washers and carriage
bolts previously removed. Attach these hardware
on the lower hole in the handles. See Figure 3.
Remove the lower plastic wing nut, cupped washer
and carriage bolt from each side of the lower
handle. Refer to Figure 2.
5
Product Specification
CategoriesCub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website