MTD Cub Cadet 1345 SWE 45-Inch Snow Blower Owners Manual

Reassemble the new friction wheel rubber to the
friction wheel assembly, tightening the six screws in
rotation and with equal force. It is important to
assemble the rubber on the friction wheel
symmetrically for proper functioning.
NOTE: If the sprocket fell from the snow thrower while
removing the hex shaft, place the sprocket on the hex
shaft. Position the hex hub of the sprocket toward the
friction wheel when sliding  the sprocket on  to the hex
shaft as shown in Figure 25.
Friction Wheel Plates
Shift ArmSprockSprocketet
Assembly
Pin
Spacer
Hex
Shaft
Bearing
Screws
Hex Hub
of Sprocket
Friction
Spacer
Friction Wheel
Rubber
Wheel
Hub
Figure 25
Secure with the bell washer and hex bolt removed
earlier.
Secure the frame cover with six self-tapping
screws. Put the snow thrower down to its normal
operating position.
Figure 24
Insert the pin from the shift arm assembly into the
friction wheel assembly and hold assembly in
position. Refer to Figure 23.
Slide the hex shaft through the left side of the
housing and through the friction wheel assembly.
Insert the hex shaft through the sprocket and the
spacer. Make certain that the chain engages both
the large and the small sprocket.
NOTE: If you placed plastic film under the gas cap, be
certain to remove it.
Engine
Refer to separate engine manual for all engine
maintenance procedures.
SECTION 8:  OFF-SEASON STORAGE
WARNING: Never store engine with fuel in
tank  indoors  or  in  poorly  ventilated  areas,
where fuel fumes may reach an open flame,
spark  or  pilot  light  as  on  a  furnace,  water
heater, clothes dryer or other gas appliance.
Follow lubrication recommendations on page 12.
Always store the snow thrower in a clean, dry area.
NOTE: When storing any type   of power equipment  in
an unventilated or metal storage shed, care should be
taken to rust proof the equipment. Using a light oil or
silicone,  coat  the  equipment,  especially  any  chains,
springs, bearings and cables.
If unit is to be stored over 30 days, prepare engine
for storage as instructed in the engine manual.
Remove all debris from the exterior of equipment.
17
Product Specification
CategoriesCub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website