MTD Cub Cadet 1345 SWE 45-Inch Snow Blower Owners Manual

Using a 1/2 wrench, remove the hex screw and
belleville washer from the center of the pulley on
the auger housing. Lift the brake bracket assembly
out of the pulley groove and remove the pulley. See
Figure 20. Be careful not to lose the key.
Engine Pulley
Remove and replace auger belt inside belt keepers.
Reassemble pulley to auger housing with hex
screw and belleville washer (cupped side toward
the pulley). Make sure key is in place on shaft and
brake puck is seated in the pulley groove.
Reassemble the belt cover and chute directional
control.
Proper Adjustment: With the auger clutch lever in the
disengaged position the top surface of the new belt
should be even with the outside diameter of the pulley.
Shoulder Bolt
To adjust, disconnect ferrule from brake bracket
assembly and thread ferrule in (towards idler) to
increase tension on belt, and out to decrease tension.
Figure 18
Auger Belt
Remove the cotter pin and washer from the ferrule
NOTE: The brake puck must always be firmly seated in
the  pulley  groove  when  the  auger  control  is  in  the
disengaged position.
Auger Belt
Brake Bracket Assembly
Idler Pulley
in order to disconnect the auger idler rod from the
brake bracket assembly as shown in Figure 19.
Slip the auger control belt (the front belt) off the
engine pulley. See Figure 19 .
Pull the brake bracket assembly towards the cable
guide roller and unhook the auger cable Z fitting.
Remove the upper bolts and lock washers which
attach the auger housing assembly to the frame
assembly using a 9/16 wrench. Refer to Figure 17.
Auger Pulley
Engine
Pulley
Auger
Control
Belt
Auger
Idler
Rod
Ferrule
Hex Screw
Belt Keepers
Belleville Washer
Brake
Bracket
Assembly
Figure 20
Cable
Roller
Guide
Drive Belt
Unhook the extension spring from the belt cover
plate. See Figure 21.
Z
Fitting
Remove drive belt from the engine pulley and
bottom drive pulley. Refer to Figure 21.
Figure 19
Separate the auger housing from the frame
assembly by tilting the housing forward and pulling
up the handles.
Replace belt and reassemble in reverse order.
Reassemble the two halves of the unit hooking the
lower portion of the auger housing over the
stationary shoulder bolts in the frame assembly.
Secure the two halves with the two bolts and lock
washers removed earlier. Refer to Figure 17.
15
Product Specification
CategoriesCub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website