MTD Cub Cadet 826 SWE 1130 SWE Snow Blower Owners Manual

Operating Tips
Discharge the snow downwind whenever possible.
Slightly overlap each previous path.
NOTE: Allow the engine to warm up for a few minutes.
The engine will  not develop  full power  until it reaches
operating temperature.
Set the skid shoes 1/4" below the shave plate for
normal usage. The skid shoes may be adjusted
upward (to lower the shave plate) for hard-packed
snow. Adjust downward (to raise the shave plate)
when using on gravel or crushed rock.
WARNING:    The    temperature    of    the
muffler  and  the  surrounding  areas  may
exceed 150°F. Avoid these areas.
Be certain to follow the precautions found in the To
Stop Engine section to prevent possible freeze-up.
For the most efficient snow removal, remove snow
immediately after it falls.
Clean the snow thrower thoroughly after each use.
SECTION6:  MAKINGADJUSTMENT
Remove the frame cover underneath the snow
thrower by removing the six self-tapping screws.
Axle Shaft
Sprocket
Hex Shaft
Drive Shaft
With the traction control released, there must be
clearance between the friction wheel and the drive
plate in all positions of the shift lever.
Chain
With the traction control engaged, the friction wheel
must contact the drive plate. See Figure 9.
Hairpin
Clip
Shift Lever
Drive Plate
Friction Wheel
Figure 9
Flat
WARNING:  NEVER  attempt  to  clean  the
chute or make any adjustments while the
engine is running.
Washer
Ferrule
Clutch Rod
Connector
Upper Shift Rod
Hairpin Clip
Skid Shoe Adjustment
The space between the shave plate and the ground can
be adjusted by raising or lowering the skid shoes. Refer
to Skid Shoe Adjustment in Section 3 of this manual.
Lower Shift Rod
Traction Control Adjustment
Shift Arm
Refer to the information found under the heading Final
Adjustments in Section 3 of this manual to adjust the
traction control. If you are uncertain that you have
reached the correct adjustment, proceed as follows:
Figure 10
If adjustment is necessary:
Loosen the jam nut on the traction drive cable
(Figure 5). Adjust the cable as necessary.
WARNING: Drain the gasoline out of your
snow throwers engine, or place a piece of
plastic  film  under  the  gas  cap  to  avoid
spillage before making this adjustment.
Retighten the jam nut to secure the cable when
correct adjustment is reached and reassemble.
Tip the snow thrower forward, allowing it to rest on
the auger housing.
NOTE: If you placed plastic film under the gas cap, be
certain to remove it before operating the snow thrower.
10
Product Specification
CategoriesCub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals
Tags, , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website