MTD Cub Cadet 826 SWE 1130 SWE Snow Blower Owners Manual

Reassemble the new friction wheel rubber to the
friction wheel plates and hub, tightening the six
screws in rotation and with equal force.
Position the friction wheel assembly up onto the pin
of the shift rod assembly, and slide the hex shaft
through the friction wheel assembly. Reassemble  
in reverse order.
Shift Rod Assy
Pin
Axle Shaft
Hex Shaft
NOTE: If you placed plastic film under the gas cap, be
certain to remove it.
Friction
Wheel
Assembly
Drive Shaft
Drive
Cover
Screws
Left
Drive
Cover
Figure 19
Off-Season Storage
WARNING: Never store an engine with fuel
in the tank indoors or in poorly ventilated
areas, where fuel fumes may reach an open
flame, spark or pilot light as on a furnace,
water  heater,   clothes  dryer   or  any   gas
appliance.
Frame
Cover
Left Axle
If the unit is to be stored for over 30 days, prepare
the engine for storage as instructed in the separate
engine manual packed with your unit.
Figure 18
Remove all debris from the exterior of the engine
and equipment.
Follow the lubrication recommendations found in
Section 7 of this manual.
Always store the snow thrower in a clean, dry area.
NOTE: When storing any type   of power equipment  in
an unventilated or metal storage shed, care should be
taken to rust proof the equipment. Using a light oil or
silicone,  coat  the  equipment,  especially  any  chains,
springs, bearings and cables.
14
Product Specification
CategoriesCub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals
Tags, , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website