MTD Cub Cadet 826 SWE 1130 SWE Snow Blower Owners Manual

SECTION2:  LOOSEPARTS
The snow thrower is shipped with the following loose parts in the carton. Please remove all loose parts from the
carton before discarding it. See Figure 1 to identify the parts, noting that these parts may be referred to again in the
following sections of the manual. Part numbers are shown in parentheses.
Auger Shear Bolts
The augers are secured to the auger shaft with two shear bolts and
hex lock nuts. If you hit a foreign object or ice jam, the snow thrower
is designed so that the bolts may shear. Two replacement shear
Shear Bolts
(710-0890A)
Hex Lock Nuts
(712-0429)
bolts and nuts are provided for your convenience. Store in a safe
place until needed.
IMPORTANT: NEVER replace the auger shear bolts with standard
hex bolts. Any damage to the auger gearbox or other components
as a result of doing so will NOT be covered by your snow thrower’s
warranty.
Figure 1
SECTION3:  ASSEMBLINGYOURSNOWTHROWER
NOTE: Any reference in this manual to the left or right
side   of   the  snow   thrower   is   observed   from   the
operator’s position.
Lower Handle
Handle Panel
IMPORTANT: Make any final adjustments as instructed
later on in this section BEFORE operating your snow
thrower. Failure to follow the instructions may cause
damage to the snow thrower.
Upper Handle
Wing Nuts,
Washers
and Bolts
Remove the screws from the top, sides, and ends
of the shipping carton.
Set the panels aside to avoid tire punctures or
personal injury.
Figure 2
Remove and discard the plastic bag that covers the
unit.
Roll the unit out of the carton.
Upper
Shift Rod
Remove the lower two plastic wing nuts, cupped
washers and carriage bolts from each side of the
lower handle. See Figure 2.
Shift Rod
Connector
Raise the upper handle assembly until it locks over
the lower handle. See Figure 3.
Look at the lower rear of the snow thrower frame to
be sure all the cables are aligned with the cable
roller guides.
Lower
Shift Rod
Secure the upper handle and lower handle with the
two plastic wing nuts, cupped washers and carriage
bolts previously removed and tighten the upper two
plastic wing nuts.
Figure 3
Slide the shift rod connector down over the end of
the lower shift rod. See Figure 3. Tap the connector
until it locks over the lower shift rod.
NOTE: If the connector is not properly assembled, the
shift rod will pivot and you will not be able to change
speeds or change directions.
5
Product Specification
CategoriesCub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals
Tags, , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website