MTD Cub Cadet 826 SWE 1130 SWE Snow Blower Owners Manual

Adjust skid shoes as follows:
Loosen, but do NOT remove, the three hex nuts
which fasten the skid shoe to the auger housing.
Move the skid shoe to the desired position.
NOTE: Make certain the entire bottom surface of the
skidshoe is against the ground to avoid uneven wear on
the skid shoes.
Retighten the hex nuts loosened earlier.
Repeat this adjustment on the skid shoe found on
the opposite side of the snow thrower.
Shave Plate
Carriage Bolts
NOTE: The skid shoes are reversible on this machine.
When one side wears out, it can be    rotated 180° and
the other flat skid surface can be used.
Skid Shoes
High
Low
Hex Nuts
Figure 6
SECTION4:  KNOWYOURSNOWTHROWER
Auger Control
Auger
Control
Electric
Chute-Rotation
Switch
Traction Control /
Auger Control Lock
The auger control is located on the left handle. See
Figure 7. Squeeze the auger control lever to engage
the augers. Release to stop the snow throwing action
(the traction control must also be released).
Heated Handles
Switch
Handles
Traction Control / Auger Control Lock
The traction control is located on the right handle. See
Figure 7. Squeeze the traction control to engage the
wheel drive. Release to stop.
Shift
Lever
This  same  lever  also  locks  the  auger  control  so  you
can operate the electric chute rotation switch without
interrupting  the  snow  throwing  process.  If  the  auger
control  is  engaged  simultaneously   with  the  traction
control, the operator can release the auger control (on
the left handle) and the augers will     remain engaged.
Release  the  traction  control  to  stop  the  augers  and
wheel drive (the auger control must also be released).
Chute
Tilt
Control
Left Wheel
Steering Control
Right Wheel
Steering Control
Figure 7
Shift Lever
The shift lever is located in the center of the
handle panel and is used to determine both
ground speed and direction of travel. It can
be moved into any of eight positions.
Electric Chute-Rotation Switch
The electric chute-rotation switch is located on the left
side of the snow thrower handle panel.
To change the direction in which discharged snow is
thrown, proceed as follows:
Forward
Your snow thrower has six forward (F)
speeds. Position one (1) is the slowest and
position six (6) is the fastest.
Push the toggle switch to the left to rotate the chute
counterclockwise.
Push the toggle switch to the right to rotate the
chute clockwise.
Reverse
Your snow thrower has two reverse (R)
speeds. R1 and R2, R2 is the faster speed.
IMPORTANT: Release the switch once the chute has
completed its rotation cycle in either direction. Failure to
do so can result in damage to the electric chute motor
and/or its drive gear.
IMPORTANT: Always release the traction
control before changing speeds.
7
Product Specification
CategoriesCub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals
Tags, , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website