•
Replace both auger drive belts by following
instructions in reverse order.
Friction Wheel
Wheel
Drive
Pulley
Drive Plate
Drive Belt
Stop Bolt
Auger
Drive
Wheel
Drive
Pulley
Belt
Idler
Pulley
Idler
Pulley
Support Bracket
Auger
Drive
Belts
Figure 16
Replacing Friction Wheel Rubber
Frame
The rubber on the friction wheel is subject to wear and
should be checked after 25 hours of operation, and
periodically thereafter. Replace the friction wheel
rubber if any signs of wear or cracking are found.
Figure 14
•
•
•
•
•
Drain the gasoline from the snow thrower, or place
a piece of plastic under the gas cap.
Tip the snow thrower up and forward, so that it rests
on the housing.
Remove the six self-tapping screws from the frame
cover underneath the snow thrower.
Remove the click pin that secures the left wheel to
the axle and slide the wheel from the axle.
Remove the four screws securing the left drive
cover to the frame. Remove the drive cover. See
Figure 18.
NOTE: If you placed plastic film under the gas cap, be
certain to remove it before operating the snow thrower.
Drive Belt
•
•
•
•
Follow the first four steps of the instructions for
servicing the auger belts.
Pull the idler pulley up, and lift the belt off the wheel
drive pulley and friction wheel disc. See Figure 15.
Back out the stop bolt until the support bracket
rests on the auger pulley. See Figure 16.
Slip the belt between the friction wheel and drive
disc. See Figure 16. Remove and replace the belt.
Reassemble following the instructions in reverse
order.
Screws
Friction Wheel Rubber
Hub
NOTE: The support bracket must rest on the stop bolt
after the new belt has been assembled. See Figure 16.
Screws
Support
Bracket
Friction Wheel Plates
Figure 17
Rear
•
Holding the friction wheel assembly, slide the hex
shaft out of the left side of the frame. See Figure 19.
The spacer on the right side of the hex shaft will fall
and the sprocket should remain hanging loose in
the chain.
Lift the friction wheel assembly out between the
axle shaft and the drive shaft assemblies.
Remove the six screws from the friction wheel
assembly (three from each side). Remove the
friction wheel rubber from between the friction
wheel plates. See Figure 17.
Auger
Frame
Belt
Front
Auger
Belt
•
•
Auger
Pulley
Support
Bracket
Spring
Idler
Auger
Spring Housing
Figure 15
13
| Categories | Cub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Cub Cadet 1130 SWE, Cub Cadet 826 SWE, MTD 1130 SWE, MTD 826 SWE, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)