Wheel Drive Control / Auger Control Lock
•
•
Remove the six self-tapping screws from the frame
cover underneath the snow thrower.
Visually inspect the friction wheel rubber for
excessive wear, cracks, or loose fit on the friction
wheel drive hub.
Engage the traction control and check if the friction
wheel is making solid contact with drive plate (Refer
to Figure 12). If it does not, adjust the lock nut on the
lower end of the wheel drive cable following the
instructions on page 7 and recheck the friction
wheel.
The cams on the ends of the control rods which interlock
the wheel drive and auger drive controls must be
lubricated at least once a season or every 25 hours of
operation using a multi-purpose automotive grease. The
cams can be accessed from beneath the handle panel.
See Figure 16.
•
Handle Panel
•
•
Replace the friction wheel rubber if necessary. Refer
to instructions on page 17.
Re-install the frame cover, lower the snow thrower
back onto its wheels, and remove plastic film from
the fuel tank.
Drive Belts
Follow the instructions below to check the condition of
the drive belts every 50 hours of operation.
Lube Cams Here
Control Rods
•
Remove the plastic belt cover on the front of the
engine by removing the three self-tapping screws
and flat washers.
Figure 16
•
•
Visually inspect for frayed, cracked, or excessively
worn belts.
Friction Wheel Rubber
Follow the instructions below to check the condition of
the friction wheel rubber every 25 hours of operation.
Replace belts as necessary as outlined in Service
Section on page 15.
•
•
Drain the gasoline out of your snow thrower’s
engine, and place a piece of plastic film under the
gas cap to avoid spillage.
Tip the snow thrower forward, allowing it to rest on
the auger housing.
Engine
Refer to the accompanying engine manual for all engine
maintenance instructions and the required intervals for
performing the procedures.
14
| Categories | Cub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Cub Cadet 928 SWE, Cub Cadet 933 SWE, Cub Cadet 945 SWE, MTD 928 SWE, MTD 933 SWE, MTD 945 SWE, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)