Attaching Chute Crank
Engine
Alternator
Lead
•
Remove the internal cotter pin from the upper chute
crank. Slide the upper chute crank through the
upper chute crank bracket and into the sleeve on
the lower chute crank.
•
Align the hole in the upper chute crank with the hole
in the sleeve (If necessary, use a pair of pliers to
assist in aligning holes). Insert the internal cotter
pin through the holes to secure the chute crank.
See Figure 3.
Lamp Wire
Upper Chute Crank
Figure 5
Normally the cable ties holding the steering cables
against the handle are loosely installed on each side of
the lower handle at the factory. Pull the cable ties tight
to secure. Cut the excess from the ends of cable ties.
Upper Chute
Crank Bracket
Final Assembly Adjustments
Make these final assembly adjustments before
operating your snow thrower for the first time. Failure to
follow these instructions may cause damage to the
snow thrower.
Internal
Cotter Pin
Lower Chute Crank
To test the wheel drive and auger drive controls, Refer
to Figure 6 and proceed as follows:
Figure 3
If not already done, slip the cables that run from the
handle panel to the discharge chute into the cable
guide located on top of the engine. See Figure 4.
Wheel Drive
Control Released
Shift Lever
Auger Drive
Control Released
Cable
Cable
Guide
Figure 6
Testing Wheel Drive Control & Shift Lever
Perform the following test to determine need for
adjustment:
Discharge
Chute
•
Move the shift lever into sixth (6) position. Refer to
Figure 6.
Figure 4
•
With the wheel drive control released, push the
snow thrower forward, then pull it back. The
machine should move freely.
Engage the wheel drive control and attempt to
move the machine both forward and back,
resistance should be felt.
Wrap the wire of the head lamp wire harness down the
right handle until the wire can be plugged into the
engine alternator wire connector down on the engine.
See Figure 5.
•
•
Move the shift lever into the fast reverse (R2)
position and repeat the previous two steps.
6
| Categories | Cub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Cub Cadet 928 SWE, Cub Cadet 933 SWE, Cub Cadet 945 SWE, MTD 928 SWE, MTD 933 SWE, MTD 945 SWE, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)