MTD Troy-Bilt Zero Turn Tractor RZT 50 W Inch Deck Lawn Mower Owners Manual

K.   Fuel Tank Cap
Indicator Panel Features
The  fuel  tank  cap  is  located  at  the  rear  of  the  LH
console.  Turn  the  cap  counterclockwise  to  unscrew
and remove from the fuel tank. Always re-install the
fuel cap tightly onto the fuel tank after removing.
Battery Indicator (Refer to Figure 7)
Illuminates  and  the  battery  voltage  is  displayed
briefly  when  the  ignition  switch  it  turned  to  the
"ON" position.
Illuminates  to  indicate   the  battery  voltage  has
dropped below 11.5 (+0.5/-1.0) volts. The battery
voltage is also displayed on the hour meter. If this
indicator  and  display  come  on  during  operation,
check the battery and charging system for possi-
ble causes and/or contact your authorized Troy-
Bilt Service Dealer.
WARNING:  Never  fill  the  fuel  tank  when
the engine is running. If the engine is hot
from  recently  running,  allow  to  cool  for
several  minutes  before  refueling.  Highly
flammable  gasoline   could   splash  onto
the engine and cause a fire.
L.   Hour Meter/Indicator Panel
The hour meter/indicator panel is located on the LH
console to the left of the operator’s seat.
Oil Pressure Indicator (Refer to Figure 7)
This   warning   lamp   indicates   low   engine   oil
pressure.  If  the   indicator  comes  on   while  the
engine  is  running,  stop  the  engine  immediately
and  check  for  possible  causes.  Do  not  run  the
engine while this indicator is illuminated. Contact
your authorized Troy-Bilt Service Dealer to have
the tractor and engine inspected.
Battery
Indicator
Oil Pressure
Indicator
RZT50 only
Hour
NOTE:  The   oil   pressure  indicator   may  illuminate
when  the  ignition  switch  is  in  the  ON  position,  but
should turn off when the engine is started.
Meter
PTO
Parking Brake
Engaged
Indicator
Engaged
Indicator
PTO Engaged Indicator (Refer to Figure 7)
This indicator illuminates when the PTO switch is
pulled  upward  in  the  "ENGAGED"  position  and
the  ignition   switch   is  turned   to  the   "START"
position. Check this indicator if the engine will not
crank  with  the   ignition  switch  in  the   "START"
position.  If  necessary,  move  the  PTO  switch  to
the "DISENGAGED" position.
Figure 7  
HourHour Meter Features
The hour meter records the hours that the tractor has
been  operated  in  the   digital  display  (tenths  of  an
hour-right most digit).
NOTE: The hour meter is activated whenever the igni-
tion  switch  is  turned  to  the   "ON"  position.  Keep  a
record  of  the  actual  hours  of  operation  to  assure  all
maintenance  procedures  are  completed  according  to
the instructions in this manual and the engine manual.
Parking Brake Engaged Indicator (Refer to Figure 7)
This indicator illuminates when the parking brake
is in the DISENGAGED position and the ignition
switch is turned to the "START" position. Check
this indicator if the engine will not crank with the
ignition switch in the "START" position. If neces-
sary, move the parking brake to the ENGAGED
position.
When  key  is  turned   to  the  "ON"  position,  the
battery  indicator  light  briefly  illuminates  and  the
battery  voltage  is  briefly  displayed.  The  display
then changes to the accumulated hours.
This  indicator  also  illuminates  when  the  ignition
switch is turned to  the "START" position  and the
RH and/or LH drive control levers are in a posi-
tion  other  than  the  fully  out  in  neutral  position.
Move the control levers fully outward.
The   Indicator    Monitor   will   also   remind    the
operator  of  maintenance  intervals  for  changing
the  engine  oil.   The  LCD  will  alternately  flash,
“CHG”  ;  “OIL”  and  the  recorded  hours  for  five
minutes   after    every   50    hours   of    recorded
operation. The maintenance interval lasts for two
hours (from 50-52, 100-102, 150-152, etc.). The
LCD will flash as described for five minutes every
time  the  tractor’s  engine  is   started  during  this
maintenance  interval.   Follow  the   oil   change
intervals provided in the engine manual.
13
Product Specification
CategoriesLawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 36 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Lawn Mower
Product TypeWalk Behind Mower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website