MTD Troy-Bilt Zero Turn Tractor RZT 50 W Inch Deck Lawn Mower Owners Manual

Remove the hex cap screw and sems nut secur-
ing the black negative battery lead to the negative
battery post (marked NEG). Move the cable away
from the negative battery post.
BATTERY STORAGE
When  storing  the  tractor  for  extended  periods,
disconnect  the  negative  battery  cable.  It  is  not
necessary to remove the battery.
Remove the hex cap screw and sems nut secur-
ing  the  red  positive  battery  lead  to  the  positive
battery post (marked POS).
All  batteries  discharge  during  storage.  Keep  the
exterior of the battery clean, especially the top. A
dirty battery will discharge more rapidly.
Carefully lift the battery out of the tractor.
The battery must be stored with a full charge. A
discharged  battery   can  freeze   sooner  than   a
charged battery. A fully charged battery will store
longer in cold temperatures than hot.
Install the battery by repeating the above steps in the
reverse order.
WARNING:  Always  connect  the  positive
lead to the battery before connecting the
negative  lead.  This  will  prevent  sparking
or possible injury from an electrical short
caused by contacting the tractor body with
tools being used to connect the cables.
Recharge  the  battery  before  returning  to  service.
Although the tractor may start, the engine charging
system may not fully recharge the battery.
SERVICING ELECTRICAL SYSTEM
A  fuse  is  installed  to  protect  the  tractor’s  electrical
system  from  damage  caused  by  excessive  amper-
age.   Always    use   the   same    capacity   fuse    for
replacement.  If  the  electrical  system  does  not  func-
tion, check for a blown fuse. See Figure 24
If  you  have  a  recurring  problem  with  blown  fuses,
have the tractor’s electrical system checked by your
authorized Troy-Bilt Service Dealer.
CHARGING THE BATTERY
Test and, if necessary, recharge the battery after the
tractor has been stored for a period of time.
A voltmeter or load tester should read 12.6 volts
(DC) or higher across the battery terminals.
Charge the battery with a 12-volt battery charger
at a MAXIMUM rate of 10 amps.
Voltmeter
Reading
12.7
State of
Charge
100%
75%
Charging
Time
Full Charge
90 Min.
12.4
GOOD
BAD
12.2
12.0
50%
25%
180 Min.
280 Min.
Figure 24  
Relays and Switches
BATTERY MAINTENANCE
There  are  several  safety  switches  in  the  electrical
system.  If  a  function  of  the  safety  interlock  system
described earlier is not functioning properly, have the
electrical  system  checked  by  your  authorized  Troy-
Bilt Service Dealer.
The battery is filled with battery acid and then sealed
at  the  factory.  However,  even  a  “maintenance  free”
battery  requires   some  maintenance   to  ensure   its
proper life cycle.
Spray  the  terminals   and  exposed  wire  with   a
battery terminal sealer, or coat the terminals with
a thin coat of grease or petroleum jelly, to protect
against corrosion.
LUBRICATION
Using  a  pressure  lubricating  gun,  lubricate  the
front  castor  axles  and  pivot  axle  with  a  No.  2
multi-purpose  grease   after  every   10  hours   of
service.
Always  keep  the   battery  cables  and  terminals
clean and free of corrosion.
Refer to the "MOWER DECK" section later in this
manual for deck lubrication procedures.
Avoid  tipping.  Even  a   sealed  battery  will  leak
electrolyte when tipped.
Periodically lubricate all other pivot points with a
quality lubricating oil.
24
Product Specification
CategoriesLawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 36 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Lawn Mower
Product TypeWalk Behind Mower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website