MTD Troy-Bilt Zero Turn Tractor RZT 50 W Inch Deck Lawn Mower Owners Manual

M.  Throttle Control
Rear Bumper (Not Shown)
The  throttle  control  is  located  on  the  LH  console  to
the  left  of  the  operator’s  seat.  When  set  in  a  given
position, a uniform engine speed will be maintained.
This   tractor   is  equipped   with   a   removable   rear
bumper. The rear bumper provides protection during
turns  to  the  rear  of   the  tractor  frame  and  to  any
engine components that may be near the rear tractor
frame.
This symbol indicates the
fast position.
The  rear  bumper  must  be  removed  from  the  tractor
when installing a Rear Bagger Kit. Or you may want
to remove the bumper to reduce the over-all length of
the tractor. To Remove the rear bumper, proceed as
follows:
This symbol indicates the
slow position.
Figure 8  
From the inside  surface of  the tractor frame,  just
rearward  of   the  rear  tire   on  one  side   of  the
tractor, pull the internal cotter pin from   the clevis
pin. See  Figure 9.  Remove the interna  cotter pin
from the clevis pin on the other side of the tractor.
Push  the  throttle  control  handle  forward  to   in-
crease the engine speed. The tractor is designed
to  operate  with   the  control  handle  in  the  fast
position  (full  throttle)  when  the  tractor  is  driven
and the mower deck is engaged.
Rear Bumper
Pull  the  throttle  control  handle  rearward  to  de-
crease the engine speed.
N.   Choke Control
Withdraw
Clevis Pin
The choke knob controls the position of the engine
choke. Pull the knob out to choke the engine; push the
knob in to open the choke.
O.   Parking Brake Engagement Lever
The  parking  brake  engagement  lever  is  located  on
the  front/left  of  the  seat  box  frame,  and  is  used  to
engage the parking brake.
Remove
Internal
Cotter Pin
Pull  the  lever  fully  upward  and  to  the  left  and
lower  into  the   "J"  slot  to   engage  the  parking
brake.
Figure 9  
Pull  the  lever  up  out  of  the  "J"  slot  and  to  the
right;  then   lower  completely  to   disengage  the
parking brake.
While  supporting  the  rear  bumper,  withdraw  the
clevis pin from both sides of the bumper. Pull the
rear bumper rearward off of the tractor frame.
IMPORTANT: If the LH and RH drive control levers
are not fully opened out in the neutral position when
engaging the parking brake, the engine will stop. The
parking brake must be placed in the engaged position
when starting the tractor engine.
14
Product Specification
CategoriesLawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 36 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Lawn Mower
Product TypeWalk Behind Mower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website