MTD Troy-Bilt TB70SS 2 Cycle Gasoline Trimmer Owners Manual

RULES FOR SAFE OPERATION
SAFETY AND INTERNATIONAL SYMBOLS
This operator's manual describes safety and international symbols and pictographs that may appear on this product.  Read the
operator's manual for complete safety, assembly, operating and maintenance and repair information.
SYMBOL
MEANING
SYMBOL
MEANING
SAFETY ALERT SYMBOL
Indicates danger, warning or caution. May be
used in conjunction with other symbols or
pictographs.
ON/OFF STOP CONTROL
ON / START / RUN
ON/OFF STOP CONTROL
OFF or STOP
WARNING - READ OPERATOR'S
MANUAL
Read the operator’s manual(s) and follow all
warnings and safety instructions. Failure to do
so can result in serious injury to the operator
and/or bystanders.
KEEP BYSTANDERS AWAY
WARNING: Keep all bystanders,
especially children and pets, at least 50 feet
(15 m) from the operating area.
WEAR EYE AND HEARING
PROTECTION
WARNING: Thrown objects and loud noise
can cause severe eye injury and hearing loss.
Wear eye protection meeting ANSI Z87.1
standards and ear protection when operating
this unit. Use a full face shield when needed.
HOT SURFACE WARNING
Do not touch a hot muffler, gear housing or
cylinder. You may get burned. These parts get
extremely hot from operation. They remain hot
for a short time after the unit is turned off.
UNLEADED FUEL
Always use clean, fresh unleaded fuel
THROWN OBJECTS AND
ROTATING CUTTER CAN CAUSE
SEVERE INJURY
OIL
Refer to operator’s manual for the proper
type of oil.
WARNING: Do not operate without the
cutting attachment shield in place.  Keep
away from the rotating cutting attachment.
OIL AND FUEL INFORMATION
OIL AND FUEL MIXING INSTRUCTIONS
ratio. Do not mix them directly in the engine fuel tank. See the
table below for specific gas and oil mixing ratios.
Old and/or improperly mixed fuel are the main reasons for the unit
not running properly. Be sure to use fresh, clean unleaded fuel.
Follow the instructions carefully for the proper fuel/oil mixture.
NOTE:
One gallon (3.8 liters) of unleaded gasoline mixed with
one 3.2 oz. (95 ml.) bottle of 2-cycle oil makes a 40:1
fuel/oil ratio.
Definition of Blended Fuels
NOTE:
Dispose of the old fuel/oil mix in accordance to
Federal, State and Local regulations.
Today's fuels are often a blend of gasoline and oxygenates
such as ethanol, methanol, or MTBE (ether). Alcohol-blended
fuel absorbs water. As little as 1% water in the fuel can make
fuel and oil separate. It forms acids when stored. When using
alcohol-blended fuel, use fresh fuel (less than 60 days old).
+
Using Blended Fuels
If you choose to use a blended fuel, or its use is unavoidable,
follow recommended precautions:
UNLEADED GAS
GALLON US
2 CYCLE OIL
Always use the fresh fuel mix explained in your operator's manual
Always agitate the fuel mix before fueling the unit
Drain the tank and run the engine dry before storing the unit
1
3.2 FL. OZ.
(95 ml)
(3.8
LITERS)
1
LITER
25 ml
Using Fuel Additives
MIXING RATIO - 40:1
The bottle of 2-cycle oil that came with your unit contains a fuel
additive which will help inhibit corrosion and minimize the
formation of gum deposits. It is recommended that you use our 2-
cycle oil with this unit. If unavailable, use a good 2-cycle oil de-
signed for air-cooled engines along with a fuel additive, such as
®
STA-BIL  Gas Stabilizer or an equivalent. Add 0.8 oz. (23 ml.) of
fuel additive per gallon of fuel according to the instructions on the
container. NEVER add fuel additives directly to the unit's fuel tank.
WARNING: Gasoline is extremely flammable.
Ignited vapors may explode. Always stop the engine
and allow it to cool before filling the fuel tank. Do not
smoke while filling the tank. Keep sparks and open
flames at a distance from the area.
WARNING: Remove fuel cap slowly to avoid
injury from fuel spray. Never operate the unit without
the fuel cap securely in place.
Thoroughly mix the proper ratio of 2-cycle engine oil with
unleaded gasoline in a separate fuel can. Use a 40:1 fuel/oil
CAUTION: For proper engine operation and
maximum reliability, pay strict attention to the oil and
fuel mixing instructions on the 2-cycle oil container.
Using improperly mixed fuel can severely damage
the engine.
WARNING: Add fuel in a clean, well ventilated
outdoor area. Wipe up any spilled fuel immediately.
Avoid creating a source of ignition for spilt fuel. Do
not start the engine until fuel vapors dissipate.
3
Product Specification
CategoriesLawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 56 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Lawn Mower
Product TypeWalk Behind Mower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(1 votes, average: 2 out of 2)
Lawn and Garden readers have rated MTD Troy-Bilt TB70SS 2 Cycle Gasoline Trimmer Owners Manual 2.0 out of 2.0 based on 1 product reviews.
Submit your review (optional)
(will not be displayed)
* Required Field

MTD Troy-Bilt TB70SS 2 Cycle Gasoline Trimmer Owners Manual SKU UPC Model
Ivan Markley on Jun 20, 2015.

Won't start bulb is bad leaking air. Hasn't been a very pleasant experience with this weed wacker.


Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website