MTD Troy-Bilt TB70SS 2 Cycle Gasoline Trimmer Owners Manual

ASSEMBLY INSTRUCTIONS
On some units, the D-handle may be pre-installed, requiring
INSTALLING THE CUTTING ATTACHMENT SHIELD
only loosening screws and some adjustment. If this is the case,
go to step 4.
INSTALLING AND ADJUSTING THE D-HANDLE
Use the following instructions if the cutting attachment shield
on your unit is not installed or if you ever need to re-install it.
WARNING:  Never operate the trimmer without
the cutting attachment shield in place to prevent
serious personal injury.
1.
Remove the screws and bottom clamp piece that were
installed on the D-handle for shipping.
2.
Place D-handle the over the shaft housing and onto the
bottom clamp (Fig. 1). Place it a minimum of 6 inches
1.
Slide the cutting attachment shield into the shield mount
on the cutting attachment. Align the screw holes in the
shield with the holes in the cutting attachment (Fig. 3).
(15.24
cm) from the end of the shaft grip.
Shaft Grip
(4) Screws
Shaft
Housing
Shaft Housing
On/Off Stop Control
Minimum 6 inches
Cutting Attachment
Shield
(15.24
cm)
Shield Mount
Cutting Attachment
Fig. 3
D-Handle
Bottom Clamp
Fig. 1
2.
Place a hex lock nut into one of the three  recessed holes on
the top of the cutting attachment shield (Fig 4).
3.
Start screws with a large Flat-head or T-25 Torx
screwdriver. Do not tighten until you make the handle
adjustment.
4.
5.
If the D-handle was pre-installed, loosen the screws on the
handle just enough to move it.
While holding the unit in the operating position (Fig. 2),
position the D-handle to the location that provides you the
best grip.
Cutting Attachment
Shield
6.
Tighten the clamp screws evenly, until the D-handle is
secure.
Recessed Holes
Hex Lock Nut
Fig. 4
3.
4.
Install a screw into the hole from the bottom of the cutting
attachment shield and screw it into the nut installed in step
2
(Fig 5). Do not tighten.
Repeat steps 2 and 3 until all three screws have been
started, then tighten securely.
Screws
Fig. 5
Fig. 2
5
Product Specification
CategoriesLawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 56 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Lawn Mower
Product TypeWalk Behind Mower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(1 votes, average: 2 out of 2)
Lawn and Garden readers have rated MTD Troy-Bilt TB70SS 2 Cycle Gasoline Trimmer Owners Manual 2.0 out of 2.0 based on 1 product reviews.
Submit your review (optional)
(will not be displayed)
* Required Field

MTD Troy-Bilt TB70SS 2 Cycle Gasoline Trimmer Owners Manual SKU UPC Model
Ivan Markley on Jun 20, 2015.

Won't start bulb is bad leaking air. Hasn't been a very pleasant experience with this weed wacker.


Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website