STARTING & STOPPING INSTRUCTIONS
WARNING: Operate this unit only in a well-
ventilated outdoor area. Carbon monoxide exhaust
fumes can be lethal in a confined area.
Stop/Off (O)
Start/On ( I )
WARNING: Avoid accidental starting. Make
sure you are in the starting position when pulling
the starter rope (Fig. 11). To avoid serious injury,
the operator and unit must be in a stable position
while starting.
Throttle
Control
STARTING INSTRUCTIONS
1.
Mix gas with oil. Fill fuel tank with fuel/oil mixture.
See Oil and Fuel Mixing Instructions.
Fig. 9
NOTE: There is no need to turn the unit on. The
On/Off Stop Control is in the ON ( I ) position at all
times (Fig. 9).
2.
Fully press and release the primer bulb 10 times,
slowly. Some amount of fuel should be visible in the
primer bulb and fuel lines (Fig. 10). If you can’t see
fuel in the bulb, press and release the bulb as many
times as it takes before you can see fuel in it.
3.
4.
Place the blue choke lever in Position 1 (Fig. 10).
Crouch in the starting position (Fig. 11), squeeze the
throttle control, and pull the starter rope out with a
controlled and steady motion 5 times.
Blue Choke
Lever
NOTE: The unit uses Spring Assist Starting™, which
significantly reduces the effort required to start the
engine. You must pull the starter rope out far enough
to hear the engine attempt to start. There is no need
to pull the rope briskly-- there is no harsh resistance
when pulling. Be aware that this starting method is
vastly different from (and much easier than) what you
may be used to.
Primer Bulb
5.
6.
Place the blue choke lever in Position 2 (Fig. 10).
While squeezing the throttle control, pull the starter
rope out with a controlled and steady motion until
the engine starts.
Fig. 10
7.
Keep the throttle squeezed and allow the engine to
warm up for 15 to 30 seconds.
NOTE: Engine may take longer to warm up and reach
maximum operating speed at colder temperatures.
Starting
Position
NOTE: Unit is properly warmed up when engine
accelerates without hesitation.
Trimmer
Equipped With
8.
Once the engine is warmed up, place the blue choke
lever in Position 3 (Fig. 10). The unit is ready for use.
Spring Assist
Starting ™
IF... the engine hesitates, return the blue choke lever to
Position 2 (Fig. 10) and continue warm-up.
IF... the engine does not start, go back to step 2.
IF... the engine fails to start after a few attempts, place
the blue choke lever in Position 3 and squeeze the
throttle control. Pull the starter rope out with a
controlled and steady motion 3 to 8 times. The
engine should start. If not, repeat.
IF WARM... If the engine is already warm, start the unit
with the blue choke lever in Position 2. After the unit
starts, move the blue choke lever to Position 3.
Throttle Control
STOPPING INSTRUCTIONS
1.
Release your finger from the throttle control. Allow the
engine to cool down by idling.
Fig. 11
2.
Press and hold On/Off Stop Control in the OFF (O) position
until engine comes to a complete stop (Fig. 9).
7
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals |
|---|---|
| Tags | MTD Troy-Bilt TB70SS |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Product Type | Walk Behind Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(1 votes, average: 2 out of 2)
Lawn and Garden readers have rated MTD Troy-Bilt TB70SS 2 Cycle Gasoline Trimmer Owners Manual 2.0 out of 2.0 based on 1 product reviews. Won't start bulb is bad leaking air. Hasn't been a very pleasant experience with this weed wacker.