MAINTENANCE
HOW TO ADJUST THE AUGER CONTROL
CABLE
The auger control is adjusted at the factory. During
normal use, the auger control cable can become
stretched and the auger drive lever will not pro-
perly engage or disengage the auger.
7.
8.
(Figure 6) Install the “Z”hook (1) to the
auger drive lever (2).
To check the adjustment, start the snowthrower.
Make sure the auger does not rotate when the
auger drive is released.
1.
(Figure 6) Remove the “Z”hook (1) from the
auger drive lever (2).
1
3
2
2
4
1
2
Figure 7
Figure 6
HOW TO REMOVE THE BELT COVER
2.
3.
(Figure 7)
cable adjustment bracket (2).
1. (Figure 8) If equipped, remove the heat shield (1)
from the rear of the belt cover (2).
Push the bottom of the auger control cable (3)
through the cable adjustment bracket (2) until
the “Z”hook (6) can be removed.
2.
3.
4.
5.
Remove the four bolts and nuts (3) holding
the belt cover (2) to the auger housing.
4.
Remove the “Z”hook (4) from the cable adjust-
ment bracket (2). Move the “Z”hook (4) down to
the next adjustment hole.
Remove the one screw (4) holding the belt
cover (2) to the bottom cover (5).
To remove, hold the bottom portion of the
belt cover (2) and pull down and out.
5.
6.
Pull the auger control cable (3) up through the
cable adjustment bracket (2).
To install the belt cover (2), reverse the above
steps.
Put the cable boot (1) over the cable adjustment
bracket (2).
20
Categories | Murray Snow Blower Manuals, Snow Blower Manuals |
---|---|
Tags | Murray 1695538 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
(2 votes, average: 4 out of 4) Lawn and Garden readers have rated Murray Walk Behind 1695538 5.25TP 21-Inch Single Stage Snow Blower Owners Manual 4.0 out of 4.0 based on 2 product reviews.
I wasn’t looking for a massive snow blower. This one works really well for the size of my driveway in lighter snow conditions
Picked up used Murray snowblower last week for light jobs. Perfect size, just a little old (2007). Was looking for info re:specs for minor maintenance.