CALIFORNIA, U.S. EPA, AND BRIGGS & STRATTON CORPORATION EMISSIONS CONTROL WARRANTY STATEMENT
YOUR WARRANTY RIGHTS AND OBLIGATIONS
Effective November 2008
The California Air Resources Board, U.S. EPA, and Briggs & Stratton (B&S)
are pleased to explain the emissions control system warranty on your Model
Year 2008 and later engine/equipment. In California, new small off-road engines
must be designed, built, and equipped to meet the State’s stringent anti-smog
standards. B&S must warrant the emissions control system on your engine/
equipment for the periods of time listed below provided there has been no abuse,
neglect, or improper maintenance of your small off-road engine.
Your emissions control system may include parts such as the carburetor or
fuel injection system, fuel tank, ignition system, and catalytic converter. Also
included may be hoses, belts, connectors, sensors, and other emissions-related
assemblies. Where a warrantable condition exists, B&S will repair your engine/
equipment at no cost to you including diagnosis, parts, and labor.
Manufacturer’s Warranty Coverage:
Owner’s Warranty Responsibilities:
• As the small engine/equipment owner, you are responsible for the performance
of the required maintenance listed in your owner’s manual. B&S recommends that
you retain all receipts covering maintenance on your engine/equipment, but B&S
cannot deny warranty solely for the lack of receipts or your failure to ensure the
performance of all scheduled maintenance.
• As the engine/equipment owner, you should however be aware that B&S may
deny you warranty coverage if your engine/equipment or a part has failed due to
abuse, neglect, improper maintenance, or unapproved modifications.
• You are responsible for presenting your engine/equipment to a B&S distribution
center, servicing dealer, or other equivalent entity, as applicable, as soon as a
problem exists. The warranty repairs should be completed in a reasonable amount
of time, not to exceed 30 days. If you have any questions regarding your warranty
rights and responsibilities, you should contact B&S at (414) 259-5262.
Small off-road engines are warranted for two years. If any emissions-related part
on your engine/equipment is defective, the part will be repaired or replaced by
B&S.
BRIGGS & STRATTON EMISSIONS CONTROL WARRANTY PROVISIONS
The following are specific provisions relative to your Emissions Control Warranty
Coverage. It is in addition to the B&S engine warranty for non-regulated engines
found in the Operator’s Manual.
The warranty on emissions-related parts is as follows:
•
Any warranted part that is not scheduled for replacement as required
maintenance in the owner’s manual supplied, is warranted for the
warranty period stated above. If any such part fails during the period
of warranty coverage, the part will be repaired or replaced by B&S at
no charge to the owner. Any such part repaired or replaced under the
warranty will be warranted for the remaining warranty period.
Any warranted part that is scheduled only for regular inspection in the
owner’s manual supplied, is warranted for the warranty period stated
above. Any such part repaired or replaced under warranty will be
warranted for the remaining warranty period.
Any warranted part that is scheduled for replacement as required
maintenance in the owner’s manual supplied, is warranted for the
period of time prior to the first scheduled replacement point for that
part. If the part fails prior to the first scheduled replacement, the part
will be repaired or replaced by B&S at no charge to the owner. Any
such part repaired or replaced under warranty will be warranted for the
remainder of the period prior to the first scheduled replacement point
for the part.
1.
Warranted Emissions Parts
Coverage under this warranty extends only to the parts listed below (the
emissions control systems parts) to the extent these parts were present on
the engine purchased.
•
•
a.
Fuel Metering System
•
•
•
•
•
•
Cold start enrichment system (soft choke)
Carburetor and internal parts
Fuel pump
Fuel line, fuel line fittings, clamps
Fuel tank, cap and tether
Carbon canister
b.
Air Induction System
•
•
•
Air cleaner
Intake manifold
Purge and vent line
c.
d.
Ignition System
•
Add on or modified parts that are not exempted by the Air Resources
Board may not be used. The use of any non exempted add on or
modified parts by the owner will be grounds for disallowing a warranty
claim. The manufacturer will not be liable to warrant failures of
warranted parts caused by the use of a non exempted add on or
modified part.
•
•
Spark plug(s)
Magneto ignition system
Catalyst System
•
•
•
Catalytic converter
Exhaust manifold
Air injection system or pulse valve
3.
4.
Consequential Coverage
e.
Miscellaneous Items Used in Above Systems
•
Vacuum, temperature, position, time sensitive valves and
Coverage shall extend to the failure of any engine components caused by
the failure of any warranted emissions parts.
switches
•
Connectors and assemblies
Claims and Coverage Exclusions
2.
Length of Coverage
Warranty claims shall be filed according to the provisions of the B&S engine
warranty policy. Warranty coverage does not apply to failures of emissions
parts that are not original equipment B&S parts or to parts that fail due to
abuse, neglect, or improper maintenance as set forth in the B&S engine
warranty policy. B&S is not liable for warranty coverage of failures of
emissions parts caused by the use of add-on or modified parts.
For a period of two years from date of original purchase, B&S warrants to
the original purchaser and each subsequent purchaser that the engine is
designed, built, and equipped so as to conform with all applicable regulations
adopted by the Air Resources Board; that it is free from defects in material
and workmanship that could cause the failure of a warranted part; and
that it is identical in all material respects to the engine described in the
manufacturer’s application for certification. The warranty period begins on the
date the engine is originally purchased.
LOOK FOR RELEVANT EMISSIONS DURABILITY PERIOD AND AIR INDEX INFORMATION ONYOUR ENGINE
EMISSIONS LABEL
Engines that are certified to meet the California Air Resources Board (CARB)
Emissions Standard must display information regarding the Emissions Durability
Period and the Air Index. Briggs & Stratton makes this information available to
the consumer on our emissions labels. The engine emissions label will indicate
certification information.
The Emissions Durability Period describes the number of hours of actual
running time for which the engine is certified to be emissions compliant, assuming
proper maintenance in accordance with the Operating & Maintenance Instructions.
The following categories are used:
For example, a typical walk-behind lawn mower is used 20 to 25 hours per year.
Therefore, the Emissions Durability Period of an engine with an intermediate
rating would equate to 10 to 12 years.
Briggs & Stratton engines are certified to meet the United States Environmental
Protection Agency (USEPA) Phase 2 emissions standards. For Phase 2 certified
engines, the Emissions Compliance Period referred to on the Emissions
Compliance label indicates the number of operating hours for which the engine
has been shown to meet Federal emissions requirements.
Moderate:
Engine is certified to be emissions compliant
for 125 hours of actual engine running time.
For engines less than 225 cc displacement:
Category C = 125 hours
Category B = 250 hours
Category A = 500 hours
Intermediate:
Engine is certified to be emissions compliant
for 250 hours of actual engine running time.
Extended:
Engine is certified to be emissions compliant
for 500 hours of actual engine running time.
For engines of 225 cc or more displacement:
Category C = 250 hours
Category B = 500 hours
26 Category A = 1000 hours
| Categories | Murray Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Murray 1695538 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(2 votes, average: 4 out of 4)
Lawn and Garden readers have rated Murray Walk Behind 1695538 5.25TP 21-Inch Single Stage Snow Blower Owners Manual 4.0 out of 4.0 based on 2 product reviews. I wasn’t looking for a massive snow blower. This one works really well for the size of my driveway in lighter snow conditions
Picked up used Murray snowblower last week for light jobs. Perfect size, just a little old (2007). Was looking for info re:specs for minor maintenance.