MAINTENANCE
6.
7.
Check the spark plug. If the spark plug is
cracked, fouled, or dirty, it must be replaced.
HOW TO REPLACE THE SPARK PLUG
NOTE: This spark plug ignition system meets
all requirements of the Canadian Intereference-
Causing Equipment Regulations (ICES-002).
(Figure 14) Set the gap between the elec-
trodes of the new spark plug at .030 inch.
Next, install the spark plug in the cylinder
head and firmly tighten. Recommended
torque is 18 to 20 ft-lbs.
NOTE: This engine complies with all current
Australian and New Zealand limitations electro-
magnetic interconference.
The spark plug is housed in the engine compart-
ment under the top cover and cannot be seen
under normal conditions.
1.
(Figure 13) Open the spark plug access
door (1) on the control panel.
2.
3.
4.
The spark plug and wire are now visible.
Remove the spark plug wire.
Figure 14
Clean the area around the spark plug base
to prevent dirt from entering the engine when
the spark plug is removed.
HOW TO PREPARE THE SNOWTHROWER
FOR STORAGE
WARNING: Before you make an inspec-
tion, adjustment (except carburetor), or
5.
Remove the spark plug.
repair, disconnect the wire from the spark plug.
1.
2.
Drain the fuel tank.
1
Let the engine run until it is out of gasoline or
petrol.
3.
Remove the spark plug from the cylinder.
a. Pour one ounce of oil into the cylinder.
b. Slow pull the recoil-start grip so that the oil
will protect the cylinder.
c. Install a new spark plug in the cylinder.
Thorougly clean the snow thrower.
Figure 13
4.
5.
Lubricate all lubrication points. See the Mainten-
ance section.
23
Categories | Murray Snow Blower Manuals, Snow Blower Manuals |
---|---|
Tags | Murray 1695538 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
(2 votes, average: 4 out of 4) Lawn and Garden readers have rated Murray Walk Behind 1695538 5.25TP 21-Inch Single Stage Snow Blower Owners Manual 4.0 out of 4.0 based on 2 product reviews.
I wasn’t looking for a massive snow blower. This one works really well for the size of my driveway in lighter snow conditions
Picked up used Murray snowblower last week for light jobs. Perfect size, just a little old (2007). Was looking for info re:specs for minor maintenance.