6qwvt8h
i
r
•
Hrh
rt
rqru
with scale on filing gauge * -
at nose of Duromatic bars -
in area used most for cutting
on Rollomatic bars -
H
hhtrr
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components
(e.g. carburetion, ignition, timing and
valve or port timing) without the addition
of any major hardware.
Chain type
Rapid
Pitch
3/8"
minimum
groove depth
LA
The carburetor is set at the factory to
provide an optimum fuel-air mixture
under all operating conditions.
H
/4
3
L
1/
4
6.0 mm (0.24")
*
Special accessory
It enables your machine to run smoothly,
be fuel efficient, operate reliably and
produce low emissions.
H L
Thqh
qrvthqryhhvs
rvtvpt
h
•
•
If groove depth is less than specified:
Sryhprurtvqrih
Check the air filter and clean or
replace it if necessary
Check the spark arresting screen
and clean or replace it if necessary
8 rpvsph
i
r
rvts
uvtur
hyvqr
The drive link tangs will otherwises
crape along the bottom of the groove -
the cutters and tie straps will not ride
on the bar rails.
If the engine runs unsatisfactorily, slight
readjustment may be necessary:
Turn the high speed adjusting
screwC counterclockwise up to
/4 the stop, i.e. 3/4 turn from max.
lean setting
•
Check standard setting
warm up the engine
H
•
3
Turn the high speed adjusting
screwC and low speed adjusting
screwG clockwise (leaner) -
Turn the low speed adjusting
screwG clockwise up to the stop
- then back off the screw one
quarter of a turn
L
4
1/
Xh
vt(
If you make the setting too lean, the
maximum permissible engine speed will
be exceeded - risk of engine damage.
"%
"(
Categories | Chainsaw Manuals, STIHL Chainsaw Manuals |
---|---|
Tags | STIHL 036 |
Download File |
|
Language | English, Español |
Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Chainsaw |
Document File Type | |
Publisher | stihl.com |
Wikipedia's Page | Stihl |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)