Hopper Down Proximity Switch
The Pro Sweep 5200 uses a proximity switch as an inter-
lock device to prevent brush operation (rotation) when
the dump hopper is raised. This switch is normally open
and closes when the pitch frame moves the switch cam
near the target end of the switch (dump hopper low-
ered). The switch is mounted on the main sweeper
frame (Fig. 10).
7
6
5
4
3
2
8
9
Testing
10
1
Switch
Target
End
1.
Position sweeper on a level surface with dump hop-
per lowered. If sweeper is attached to towing vehicle,
engage vehicle parking brake, stop engine and remove
key from the ignition switch.
11
12
RIGHT
13
2.
machine wiring harness.
Locate hopper down switch. Disconnect switch from
14
FRONT
15
3.
Check the continuity of the switch by connecting a
Figure 10
multimeter (ohms setting) across the switch connector
terminals.
1.
2.
3.
4.
5.
6.
7.
8.
Mounting spacer
Spacer
9.
Switch cam weight
10. Carriage screw (3 used)
11. Lock nut (2 used)
12. Flat washer (2 used)
13. Hopper down switch
14. Switch spacer
Cap screw
Switch cam
Cam spacer
Flat washer
Cap screw
NOTE: Before checking switch continuity, clean target
end of switch to make sure that there is no metallic de-
bris on the switch that could prevent correct switch op-
eration.
15. Cap screw (2 used)
Flange nut (3 used)
4.
of the switch (dump hopper lowered) (Fig. 11), there
should be continuity across the switch terminals.
With the switch cam positioned near the target end
3
1
2
1
5.
When the switch cam is positioned away from the tar-
get end of the switch (dump hopper raised) (Fig. 11),
there should be no continuity across the switch termi-
nals.
IMPORTANT: Proper proximity switch operation re-
quires aluminum switch spacer that positions the
switch away from the sweeper frame. If switch is re-
moved from machine, make sure that switch spacer
is installed between switch and frame.
Figure 11
1.
2.
3.
Hopper down switch
Switch cam: dump hopper lowered
Switch cam: dump hopper raised
6.
Replace proximity switch as needed. Reconnect
switch to machine wiring harness.
Electrical System
Page 4 – 10
Pro Sweep 5200
Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
---|---|
Tags | Toro Pro Sweep 5200 |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Product Type | Walk Behind Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)