Removal (Fig. 8)
Position sweeper on a level surface with dump hop-
5. Secure pivot mounts to frame with cap screws (item
and lock nuts (item 3). Torque lock nuts from 45 to 55
ft–lb (61 to 75 N–m).
2)
1.
per empty and lowered. Have sweeper attached to tow-
ing vehicle, engage vehicle parking brake, stop engine
and remove key from the ignition switch. Chock sweep-
er wheels to prevent sweeper from moving.
6. Install hydraulic brush motor to brush housing (see
Hydraulic Brush Motor Installation in the Service and
Repairs section of Chapter 3 – Hydraulic System). Make
sure that coupling jaws have a gap between coupler jaw
valleys from .830” to .930” (21.1 to 23.6 mm). Apply Loc-
tite #242 (or equivalent) to threads of coupling set
screws. Secure coupling jaws to motor shaft and brush
shaft by torquing set screws from 125 to 155 in–lb (14.1
to 17.5 N–m) (Fig. 9).
2.
Remove hydraulic brush motor from brush housing
(see Hydraulic Brush Motor Removal in the Service and
Repairs section of Chapter 3 – Hydraulic System).
3.
4.
Support brush housing to prevent it from shifting.
Remove cap screws (item 2) and lock nuts (item 3)
7.
Lubricate grease fittings on pivot mounts (see Oper-
that secure pivot mounts to frame.
ator’s Manual).
5.
Refer to Brush Housing Service in this section for
procedure to remove brush housing from saddle frame.
5
6.
trieve brush housing.
After raising hopper and placing lift cylinder stop, re-
Antisieze
Lubricant
3
4
3
7.
and retrieve thrust washers (item 7) from between pivot
mount and brush housing.
Remove pivot mounts from brush housing. Locate
2
1
8.
If necessary, remove flange bushings from pivot
mounts. Discard bushings if removed.
Antisieze
Lubricant
6
Installation (Fig. 8)
7
125
(14.1
to 155 in–lb
to 17.5 N–m)
1.
press new bushings fully into mounts.
If flange bushings were removed from pivot mounts,
Loctite #242
Figure 9
2.
brush housing pins.
Place thrust washer and then pivot mount on both
1.
2.
3.
4.
Hydraulic brush motor
Key
5.
6.
7.
Brush
Square key
Set screw (2 per jaw)
Coupling jaw
Coupling spider
3.
4.
Position brush housing under raised hopper.
Slowly lower hopper to position brush housing to
saddle frame (see Servicing the Brush Housing in this
section).
Pro Sweep 5200
Page 5 – 11
Chassis
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro Pro Sweep 5200 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Product Type | Walk Behind Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)