Toro A 31 Two Cycle Engine Service Manual

DISASSEMBLY, INSPECTION, & REPAIR
DISASSEMBLE MAJOR
COMPONENTS (cont.)
NOTE:  If necessary, loosen the pulley re-
tainer(s) screw(s) while holding the pulley down
to provide clearance between the retainer(s)
and pulley. Torque the retainer(s) screw(s) to 20-
30 in•lb (2.3-3.4
N•m) after additional rope is
wound onto pulley.
3
2.6089.082
3.
Pull the rope out to its full length and let it
return until the pull handle rests against the
starter housing.
NOTE:  Do not add any more tension than is
necessary to make the pull handle return
against the starter housing. Adding excessive
spring tension can cause the spring to break.
If spring pressure is weak, and adjustment will
not enable the pull handle to return against the
starter housing, replace the spring.
2.6090.135
Starter Disassembly
1.
Relieve the spring tension by removing the
pull handle and allowing the pulley to slowly
unwind inside the starter housing. Make
sure the spring tension is fully relieved
before proceeding.
2.
Remove screw(s) and pulley retainer(s)
2.6089.073
3-35
Product Specification
CategoriesBlower Vacuum and Sweeper Manuals, Toro Blower and Vacuum Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 99 pages
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Blowers, Vacuums
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website