AUGER BELTS
7.
Back out the stop bolt to allow the belts to slip
between the bolt and auger pulley. See Figure 27.
NOTE: It is necessary to remove both belts in order
to change either one. If changing just one belt, be cer-
tain to check the condition of the other belt (model
NOTE: It may be necessary to loosen the six hex
nuts that fasten the frame to the auger housing to aid
in belt removal.
600/610E
has only one auger belt).
1.
Remove the plastic belt cover on the front of the
engine by removing the two self-tapping screws.
See Figure 24.
Friction
Wheel
Belt
Cover
Self-Tapping
Screws
Support
Bracket
Rear Auger
Frame
Belt
Figure 24
Front Auger
Pulley
Support
Bracket
Spring
2.
3.
4.
5.
Drain the gasoline from the snow thrower, or
place a piece of plastic under the gas cap.
Auger
Pulley
Auger
Housing
Idler
Spring
Tip the snow thrower up and forward so that it
rests on the housing.
Figure 26
Remove six self-tapping screws from the frame
cover underneath the snow thrower.
8.
9.
Lift the rear auger belt from the auger pulley, and
slip belt between the support bracket and the
auger pulley. See Figure 26. Repeat this step for
front auger belt (except models 600/610E).
Roll the front and rear auger belts off the engine
pulley. See Figure 25.
Replace both auger drive belts by following
instructions in reverse order.
Rear Auger
Belt
Drive
Belt
Engine
Pulley
DRIVE BELT
1.
2.
Follow steps 1 through 4 of previous instructions.
Front Auger
Belt
Idler
Pulley
Pull idler pulley up, and lift belt off engine pulley
and friction wheel disc. See Figure 25.
3.
4.
Back out the stop bolt until the support bracket
rests on the auger pulley. See Figure 27.
Slip belt between friction wheel and friction wheel
disc. Remove and replace belt. Reassemble fol-
lowing the instructions in reverse order.
Idler
Pulley
Engine
Pulley
NOTE: The support bracket must rest on the stop
bolt after the new belt has been assembled.
See Figure 27.
Figure 25
6.
Unhook the idler spring from the hex bolt on the
auger housing. See Figure 26.
16
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Machines Snow Blower Manuals |
|---|---|
| Tags | MTD E600E, MTD E610E, MTD E640F, MTD E660G, MTD E6C0F, MTD Snow Blower Manual, Yard Machines E600E, Yard Machines E610E, Yard Machines E640F, Yard Machines E660G, Yard Machines E6C0F |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Yard Machines, E600E, E610E, E640F, E660G, E6C0F, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)