3.
4.
5.
Remove six self-tapping screws from the frame
cover underneath the snow thrower.
Friction
Wheel
Disc
Friction Wheel
Remove the klick pins which secure the wheels,
and remove the wheels from the axle.
Drive Belt
Stop
Bolt
Using a wrench to hold the shaft, loosen, but do
not completely remove, the hex nut and bell
washer on left end of gear shaft. See Figure 28.
6.
Lightly tap the hex nut to dislodge the ball bearing
from the right side of frame. Remove the hex nut
and bell washer from left end of shaft.
7.
8.
Slide the gear shaft to the right and slide the
friction wheel assembly from the shaft.
Support Bracket
Remove the six screws from the friction wheel
assembly (three from each side). Remove the
friction wheel rubber from between the friction
wheel plate. See Figure 29.
Figure 27
CHANGING FRICTION WHEEL RUBBER
Friction Wheel
Plates
The rubber on the friction wheel is subject to wear and
should be checked after 25 hours of operation, and
periodically thereafter. Replace the friction wheel
rubber if any signs of wear or cracking are found.
Bearing
Screws
1.
Drain the gasoline from the snow thrower, or
place a piece of plastic under the gas cap.
2.
Tip the snow thrower up and forward, so that it
rests on the housing. See Figure 28.
Friction Wheel
Rubber
Hub
Figure 29
9.
Reassemble new friction wheel rubber to the
friction wheel assembly, tightening the six screws
in rotation and with equal force.
10.
Position the friction wheel assembly up onto the
pin of the shift rod assembly, and slide the shaft
through the assembly. Reassemble in reverse
order.
Hex Nut and
Bell Washer
Figure 28
SECTION 10: OFF-SEASON STORAGE
WARNING: Never store engine with fuel
in tank indoors or in poorly ventilated
areas, where fuel fumes may reach an
open flame, spark or pilot light as on a
furnace, water heater, clothes dryer or
other gas appliance.
2.
3.
Remove all dirt from exterior of engine and
equipment.
Follow lubrication recommendations in SECTION
8:
MAINTENANCE.
NOTE: When storing any type of power equipment
in a poorly ventilated or metal storage shed, care
should be taken to rust proof the equipment. Using a
light oil or silicone, coat the equipment, especially any
chains, springs, bearings and cables.
1.
If unit is to be stored over 30 days, prepare the
engine for storage as instructed in the separate
engine operator’s manual included with your unit.
carburetor.
17
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Machines Snow Blower Manuals |
|---|---|
| Tags | MTD E600E, MTD E610E, MTD E640F, MTD E660G, MTD E6C0F, MTD Snow Blower Manual, Yard Machines E600E, Yard Machines E610E, Yard Machines E640F, Yard Machines E660G, Yard Machines E6C0F |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Yard Machines, E600E, E610E, E640F, E660G, E6C0F, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)